Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• The use of accessory attachments not recommended by this appliance manufacturer may cause hazards. • Surfaces may be hot during use and during the cool down period • Do not leave this appliance unattended in use. • To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. • If an extension cord is used, please ensure it is correctly wired and rated for use with this appliance. If in doubt, consult a qualified electrician. The extension cord should be arranged so that it will not drape over the counters or table tops where it could be pulled by children or tripped over. SAVETHESEINSTRUCTIONS -2 Part identification 1. Thermostat dial 2. Power lamp 3. Heating selector 4. Carrying handle (HX280 only) 5. Cord storage 2135HX175 Cool 3 Hot 412 5 HX280 1. Off setting 2. Fan setting 3. Low heat setting 4. High heat setting -3 HX175HX175 Cordstorage(5) HX280 Cord storage (5) Features • 2000W • 2-Heat settings • Fan • Cord storage How to use your Fan Heater Caution: This product is intended for heating rooms. Do not use this appliance for any other purpose. For indoor, domestic use only. Heater Operation: • Fully unwind the cord & place the unit on a flat, even floor away from any obstructions and pointing towards the area of the room to be heated. • Rotate the heating selector (3) to setting l or ll as required, and rotate the thermostat dial (1) to maximum. • Connect the appliance to a suitable electrical supply. • The “power” lamp (2) will illuminate and warm air will be blown into the room. • When the temperature of the room is at the desired level, rotate the thermostat dial (1) slowly in an anticlockwise direction until the appliance just stops working. The “power” lamp (2) will go out. The temperature will be maintained at the present level by the thermostat inside the unit. • During this time, the “power” lamp (2) will cycle on and off with the Heater. • When it is no longer necessary to heat the room, rotate the heating selector (3) to setting “0” to switch the unit off and unplug it from the mains supply. Note: This appliance must be attended in use. Always use the product in an upright position, on a flat, level surface. Warning: In order to avoid overheating, do not cover this appliance. DenotesDonotcover -4 Fan Operation: • Fully unwind the cord & place the unit on the floor, away from any obstructions and pointing towards the area of the room to be cooled. • Rotate the heating selector (3) to the Fan setting, and rotate the thermostat dial (1) to maximum. • Connect the appliance to a suitable electrical supply. • The power lamp (2) will illuminate & cool air will be blown into the room. • Note that the fan will cycle on and off if the thermostat dial (1) is set at a lower temperature. • During operation, the “power on” (2) lamp will only be lit when the fan is running. • When it is no longer necessary to cool the room, rotate the heating selector (3) to setting “0” to switch the unit off and unplug it from the mains supply. Note: This unit must be attended in use. Warning: In order to avoid overheating, do not cover this appliance. Safety Fuse • In case of overheating, a cut-out will operate and the appliance will stop working. If the appliance stops operating, turn the heating selector (3) to 0, unplug the appliance and allow it to cool for at least 10 minutes before attempting to use it again. • In extreme conditions, a back-up cut-out will operate. This will not re-set & the appliance will need to be repaired by a qualified person. Note: This appliance is fitted with a safety device which will prevent the heater working unless it is in its normal, upright working position. How to take care of your Fan Heater Cleaning your Fan Heater • Switch off the appliance before cleaning, changing accessories or approaching parts which move in use. • Do not immerse the appliance, cord set or plug in liquids • Wipe the appliance with a damp cloth & dry thoroughly before using. Additional Safety Warnings: • Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. • Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. • Combustible materials such as furniture, pillows, bedding, papers, clothes and curtains must be kept at least 1m from the front of the appliance. • Do not allow anything to block the vents at the rear of the appliance. A gap of at least 15cm is advised. • Always use and store in a dry area. • Do not use in areas where gas, paint or other flammable goods may be present. -5 Protecting the environment Separate collection. This product must not be disposed of with normal household waste. Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not dispose it off with other household waste. Make this product available for separate collectio...
Эта инструкция также подходит к моделям:Вентиляторы - HX280 (1.65 mb)