Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
En caso de producirse, seria detectado por un termostato de seguridad que desconectaria automaticamente el aparato. • Mantengalo alejado de materiales combustibles (cortinas, etc). Una vez conectado el aparato, podra seleccionar con el interruptor tanto la potencia de calefaccion como la velocidad de ventilacion segun Fig. I. Para la regulacion del termostato,gire el mando en el sentido de las agujas del reloj, hasta que el aire caliente alcance la temperatura deseada. Cuando el local alcance la temperatura deseada, gire lentamente el mando EN SENTIDO CONTRARIO, hasta que se apague el piloto. El aparato quedara desconectado. El termostato lo conectara y desconectara automaticamente, manteniendo la temperatura en los valores elegidos. • El piloto rojo encendido indica que la calefaccion esta funcionando. • Para seleccionar el modo de giro de la rejilla difusora, gire el mando correspondiente en el sentido de las agujas del reloj segun Fig. II. • El pedal situado en la parte posterior del aparato permite posicionarlo en dos diferentes grados de inclinacion con el fin de direccionar el flujo de aire (Fig. III). • Utilice siempre el aparato en posicion vertical. WARNINGS AND OPERATING INTRUCTIONS • Before connecting the network to the set, make sure the tensions corresponds to the indicated on the characteristics plate. • When plugging in, as well as when unplugging, the switch must be in the off position. • Do not place beneath an electrical outlet, nor in the bath, shower, swimming pool, etc. • Do not stretch the cable to disconnect the plug. • Disconnect the appliance from mains when not in use. • NEVER SUBMERGE THE APPLIANCE IN WATER. • Never leave the apparatus unattended. • While the set is working it must be avoided having the aspiration mouth totally or partially covered. If this happens, when an overheating is detected by a security thermostat, it disconnects automatically the set. • Keep away from imflammable materials (cortains, etc). • Once the appliance has been switched on, both the heating power and the ventilation speed can be selected with the switch following Fig. I. • To adjust the thermostat,turn the control clockwise, until the hot air reaches the desired temperature. When the room reaches the desired temperature, turn the control ANTICLOCKWISE slowly until the pilot is off. The set will be then disconnected. The thermostat will connect and disconnect it automatically keeping the chosen temperature. • When the red light is on, this indicates the heater is working. • To select the diffuser grill turnig mode, turn the corresponding control clockwise following Fig. II. • By means of the pedal situated at the back of the appliances, this can be positioned at different inclinations in order to direct the flow of air (Fig. III). • The heater must always service in upright position. ...
Эта инструкция также подходит к моделям:Вентиляторы - CT322/01 (81.81 kb)
Вентиляторы - CT322/1(00) (81.82 kb)