Оценок - , средний балл: ( )

Инструкция по эксплуатации Raypak, модель 181/182

Производитель: Raypak
Размер: 824.36 kb
Название файла: 3fb67b81-32e9-4e3d-9e9f-19e4289de9eb.pdf

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

gasencyorafeplaceforD-2PowerVent CATALOG NO. 6000.57G Effective: 05-27-10 Replaces: 12-12-08 P/N 241086 Rev. 8 Rev. 8 reflects the following: Changes to: Fig. 2 on page 5, Fig. 4 on page 7, Fig, 5 on page 8, Dimensional Drawing on page 13, Illustrated Parts List on page 15 Additions: Note on page 4, Wiring Diagrams on pages 11-12 2 CONTENTS Warnings 3 PayAttentiontoTheseTerms 3 Receiving Equipment 4 General Specifications 4 Installation 4 Mounting the Assembly 4 Wiring a Power Vent Assembly to an Appliance with IID Ignition 7 Venting 7 Wiring Diagrams 9 182-260 H4/WH1 (Atmospheric) 9 181-261 H4/WH1 (Low NOx) 10 330-400 H4/WH1 (Atmospheric) 11 331-401 H4/WH1 (Low NOx) 12 Sequence of Operation 14 Start Up Procedures 14 Draft Proving Switch 14 Illustrated Parts List 15 WARNINGS Pay Attention to These Terms DANGER: Indicates the presence of immediate hazards which will cause severe personal injury, death or substantial property damage if ignored. WARNING: Indicates the presence of hazards or unsafe practices which could cause severe personal injury, death or substantial property damage if ignored. CAUTION: Indicates the presence of hazards or unsafe practices which could cause minor personal injury or product or property damage if ignored. NOTE: Indicates special instructions on installation, operation, or maintenance which are important but not related to personal injury hazards. NOTE: Minimum 18 AWG, 105°C, stranded wire must be used for all low voltage (less than 30 volts) external connections to the unit. Solid conductors should not be used because they can cause excessive tension on contact points. Install conduit as appropriate. All high voltage wires must be the same size (105°C, stranded wire) as the ones on the unit or larger. 3 Receiving Equipment On receiving your equipment, check the carton visual- ly for external damage. If the carton is damaged, make a note on the Bill of Lading when signing for the equip- ment. Remove the complete assembly from the carton if it is damaged, and report the damage to the carrier immediately. Be sure that you receive the number of packages indicated on the Bill of Lading. Claims for shortages and damages must be filed with the carrier by consignee. Purchased parts are subject to replacement only under the manufacturer's warranty. Debits for defec- tive replacement parts will not be accepted and defective parts will be replaced in kind only per our standard warranties. When ordering parts, you must specify Model and Serial Number of the unit. When ordering under war- ranty conditions, you must also specify date of Installation. Raypak recommends that this manual b...