Оценок - 5, средний балл: 4.2
(
)
)
|
Фрагмент инструкции
There is a fire risk if cleaning is not carried out in accordance with the instructions. Do not flambe under the rangehood. Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from appliances burning gas or other fuels. The minimum distance between the cooktop surface and the filters of the rangehood shall be 600 mm, or 650 mm if installed over a gas cooktop. Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled. If the supply cord of this equipment is damaged it must only be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. Always switch the power off prior to installation, servicing or cleaning the rangehood. Never use the rangehood without the filters in place. Stainless steel or powdercoat is very easily damaged during installation if abraded or knocked by tools. It is recommended to protect the top of the rangehood with cardboard or plastic bag during the installation to minimise the risk of damage occurring. A power outlet should be within 750 mm of the motor assembly and can be either on the wall, behind the chimney or in the ceiling. To comply with electrical safety regulations, this rangehood must be plugged into a socket near the appliance. The socket must be accessible, or have an accessible isolating switch, to enable the end user to isolate the rangehood from the power for the purpose of internal cleaning or maintenance. Ducting accessories are not supplied. All ducting must comply with local requirements and building codes. WARNING! Electrical Shock Hazard All electrical work must be done in accordance with local and/or national electrical codes as applicable. For safety, this product must be earthed. If you are unfamiliar with methods of installing electrical wiring, employ the services of a qualified electrician. Turn off power at service entrance before installing wiring or servicing this product. WARNING! Weight Hazard The rangehood is heavy. Please ensure adequate care is taken when installing the rangehood to prevent personal injury. The rangehood must be installed onto a solid wall, stud, beam or truss. Weight of the product is 6.5 kg. Installation instructions Thank you for purchasing a quality Fisher & Paykel rangehood. Each rangehood is tested and approved before it leaves the factory, ensuring our high standard of quality control is met. Contents of packaging 1 x rangehood 1 x installation instructions 4 x Spacer Tube 25.4 mm 4 x Screw 8x1.5” 4 x Screw 8x1” Typical equipment required: Electric drill Screwdriver Duct tape (if ducting) Jig saw (if ducting) Ladder (if ducting) Ducting Tape measure Drill bits Spirit level Accessories Fig.1 Slideout rangehood Accessory Part Number Replacement aluminium filter R103794 Charcoal filter R103794C Light bulb R111020 Installation instructions Height of rangehood Please read the entire instructions BEFORE installing the rangehood. Ascertain the desired installation height of the rangehood. When installing the rangehood, the lower edge of the unit must be a minimum of 600 mm (650 mm for gas cooker) above the cooking surface. The recommended position for the hood is 650 mm above the hotplates. Any installation above 750 mm will compromise the extraction performance. A = 600 min (electric cook top) A = 650 min (gas cook top) Not less than 650 mm Gas Burner Fig.2 Positioning Ducting options Some authorities require rangehoods to be vented outside. Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled. Top ducting ...
Эта инструкция также подходит к моделям:Вентиляторы - HS60CIW1 (705.16 kb)
Вентиляторы - HS60CSW1 (705.16 kb)
Вентиляторы - HS60CSX1 (705.16 kb)