Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Open the latch L and swing the grille downwards. . Fig. 10. . To remove the grid, pull it forwards from the right an. 10 release it. Grease filte. l The purpose of the grease filteris to aspirate grease particles whic. form during cooking and it must always be used, either in the extractio. or recirculate mode.. Important: the metal grease filters must be removed an. washed, either by hand or in the dishwasher, every four weeks. Hand washin. Soak grease filters for about one hour in hot water with a grease. loosening cleaner, then rinse off thoroughly with hot water. Repeat th. process if necessary. Refit the grease filters when it is dry. Dishwasher machin. Place grease filter in a dishwasher. Select most intensive washin. programme and highest temperature, at least 65°C. Repeat th. process if necessary. Refit the grease filter when it is dry. Note: when washing the metal grease filter in the dishwasher a sligh. discoloration of the filter can occur, this does not have any impact on it. performance. . Clean the inner housing using a hot detergent solution only (never us. caustic detergents, abrasive powders or brushes). Removing the filte. Open the grid and remove the stops M to take out the filter. Se. Fig. 6. Carbon filte. l The activated carbon filter should only be used if you want to us. the hood in recirculation mode. l To do this you will need an original AEG activated carbon filte. (available as an accessory). l This filter cannot be cleaned or reused. l As a general rule, the activated carbon filter should b. changed once every four months. l Mounting . Fig 1. a. Fit first rearwards on the proper seats. b. Then fix frontwards the carbon filter using hooks C. l Dismounting . Unhook the carbon filter from its housing pushing hooks C. 11 l Always specify the hood model code number and serial numbe. when ordering replacement filters. This information is shown o. the rating plate located on the inside of the unit. l The activated carbon filter can be ordered from AEG Servir. Force. Warnin. l Failure to observe the instructions on cleaning the unit an. changing the filters will cause a fire hazard. You are therefor. strongly recommended to follow these instructions. Changing the light bul. l Disconnect the unit from the mains power supply. l Remove the grid. l Replace the old light bulb with a new light bulb (40 . max.). l If the light does not come on, make sure the bulb ha. been screwed in correctly before contacting AEG Service Force. Cleanin. l Warning: always disconnect the hood from the mains powe. supply before cleaning it. Never insert pointed objects in the motor.s protective grid. l Wash the outside surfaces using a mild detergent solution. Neve. use caustic detergents or abrasive brushes or powders. l Only ever clean the switch panel and filter grille using a dam. cloth and delicate detergents. l It is extremely important to clean the unit and change the filter. at the recommended intervals. Failure to do so will cause greas. depos...
Эта инструкция также подходит к моделям:Вентиляторы - EXTRACTORHOOD 125 D (200.6 kb)
Вентиляторы - EXTRACTORHOOD 125 D (200.6 kb)
Вентиляторы - EXTRACTORHOOD 125 D (200.6 kb)
Вентиляторы - EXTRACTORHOOD 125 D (200.6 kb)