Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
See Fig. 7. Carbon filter • The activated carbon filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG activated carbon filter (see special accessories). • This filter cannot be cleaned or reused. • As a general rule, the activated carbon filter should be changed once every four months. • Mounting - Fig 8 a. Fit first rearwards on the proper seats. b. Then fix frontwards the carbon filter using hooks C. • Dismounting : Unhook the carbon filter from its housing pushing hooks C. EZD • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The activated carbon filter can be ordered from the AEG Service Force. 15 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. Changing the light bulb • Disconnect the unit from the mains power supply. • Remove the grid. • Replace the old light bulb with a new light bulb (40 W max.). • If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor's protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. •It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Accessories The following accessoires can be ordered through your retailers. MKZ telescopic wall pipe outlet hose ABS120 ,120 mm 0 Synthetic grease filter Metal grease filter MFF2 Carbon filter KFF 16 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working effectively.. Chec k that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation... The safety cut-out device has been tripped. Turn off the hob and then wait for the device to reset. If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently...
Эта инструкция также подходит к моделям:Вентиляторы - 222D (173.26 kb)
Вентиляторы - 222D (173.26 kb)
Вентиляторы - 222D (173.26 kb)
Вентиляторы - 222D (173.26 kb)