Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
off power unit. 3. For best capture of cooking impurities, your range hood should be mounted 18-24" above the cooking surface. 4. Please read specification label on product for further information and requirements. OPERATION CONTROLS The fat) and light are each controlled by a rocker switch. Th light switch has two positions, "ON" and _OFF'. The fan switch has three positions -"HIGH", "LOW", and "OFF". ("OFF" is the middle position.) CARE AND MAINTENANCE CLEANING Always disconnect the electricity from the range hood before servicing. Keep your range hood clean by using a mild detergent suitable for painted surfaces. DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS OR SCOURING POWDERS. The fan assembly is designed to be easily removed for cleaning. See "Fan Assembly RemovaF below. Aluminum filters used in vented hoods are dishwasher safe. Avoid extremely caustic cleaning agents, however. They may discolor the aluminum. Clean filters once a month. Ventless hoods are equipped with a special ventless filter. Do not wash the filter -its effectiveness will be destroyed. The ventless filter will last up to twelve months with normal use. Replace the filter whenever the blue side becomes noticeably dirty or discolored. FILTER REPLACEMENT Filters are removed by turn-(clip in low position) ing the filter retaining clip to the side and lifting the filter out. Place the filter under the embossed retain ing tabs on the back of the fan housing. Turn the filter retaining clip so that the low end of the clip holds the filter in place. In ventless hoods, MAKE SURE THAT THE BLUE Filter SIDE OF THE FILTER IS NEXT TO THE FAN WHEN THE FILTER IS INSTALLED. NOTE: Make sure that the arrows on the filter retaining clip point toward the front and back of the hood. LIGHT BULB REPLACEMENT The light bulb (not supplied with hood) should be 75 Watt maximum. Remove the light lens covering the bulb by pressing the two extending tabs together until they release from the retaining slots in the hood. Screws TO REMOVE FAN ASSEMBLY Make sure that power is disconnected. Remove filter. Remove two screws holding motor bracket to range hood. Unplug fan assembly. Be careful not to allow fan assembly to drop when screws are removed. Be careful not to bend or damage the fins on the blade Screws -they will be put out of balance. WIRING DIAGRAM WARRANTY FULLTHREEYEARWABRANTY ON PARTS r .... If within 3 years from the date of installation, any part of this range hood SK I_ II LI fails to function properly due to a defect inmatadal or workmanship, Sears MOTOR UGHT will repair the pad or furnish and install a new pad, free of charge. FULL 30-DAYWARRANTY ON FINISH ON PAINTED OR BRIGHT O LAMP I N METAL PARTS wI I If within 30 days from the date of installation, the finish on any painted or W bright metal parts of this range hood is defective in matadal or workman- I ship, Sears will furnish and install a new part, free of charge, NOTE: If any of the original wire on the hood has to be rep_lced, RANGE HOO...
Эта инструкция также подходит к моделям:Вентиляторы - 233.5334559 (174.78 kb)
Вентиляторы - 233.5134559 (174.78 kb)