Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
If you have a question or problem that your Bontrager dealer can’t handle, contact us at: Bontrager Components 920.478.4678 Attn: Customer Service 801 W. Madison Street Waterloo, Wisconsin 53594 in this manual, the Safety alert Symbol is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. COntentS Conditions for Use ........................................................................ 1 Before every ride: Checklist.......................................................... 2 Use your brakes carefully.............................................................. 3 Do not overuse the front-wheel brake....................................... 3 Make sure your brakes meet your needs ................................... 3 Be careful when riding in wet conditions.................................. 3 Installation instructions ................................................................. 4 Adjustment instructions................................................................. 6 To function check the brakes.................................................... 7 Bontrager Limited warranty.......................................................... 8 Carbon crash replacement policy .................................................. 8 Conditions for use Many bicycle parts are intended to be used in specific type or condition ofriding. It is unsafe to use a bicycle or part in a condition higher than the condition for which it is intended, as listed below: use Condition Bontrager part For riding on pavement only Riding on a paved surface where the tires do not lose ground contact Bontrager Speed Limit Road Brakeset For riding on improved paths and roadways only No jumping Condition plus smooth gravel roads and improved trails with moderate grades where the tires do not lose ground contact none For riding on unimproved trails with small obstacles Conditions and 2 plus rough trails, small obstacles, and smooth technical areas, including areas where momentary loss of tire contact with the ground may occur. nOt jumping. none For riding on rough trails with medium obstacles Conditions , 2, and 3 plus rough technical areas, moderately sized obstacles, and small jumps. none For extreme riding User caution advised Jumping, hucking, high speeds, or aggressive riding on rougher surfaces, or landing on flat surfaces. This type of riding is extremely hazardous and puts unpredictable forces on a bicycle which may overload the frame, fork, or part. none For more information about Use Conditions, visit our web site at bontrager.com. thank you for purchasing Bontrager Speed Limit Road Brakesets These caliper (side-pull) brakes are designed for Condition 1 road riding. Caliperbrakes come in different reach distances (the distance fromthe brake mounting hole tothe rim.) If these brakes donot offer the correct adjust ment to fit your bike, consult your Bontrager dealer. If the brakes are alreadyinstalled on your bike, pleaseread the following Checklistand Safety information. If thebrakes are not installed, theInstallation instructions beginon page 5. BefORe eveRy Ride: CheCkLiSt Before every ride, check your bicycle and its brakes. If your brakes do notpass inspection, readjust the brake system or take your bicycle to your dealer forservice. A Figure Bontrager Speed Limit Road Brakeset A: Brake opening lever WaRninG if your brakes are not working properly, you can lose control and fall. inspect the brakes thoroughly before every ride. do not ride the bicycle until any problem has been corrected. Squeeze each brake lever toward the handlebar to make sure the brake movesfreely and stops the bicycle. If the brake lever can be pulled to the handlebar, the brake is too loose (make sure the brake opening lever, Figure 1, is closed). When the brakes are not applied, the brake pads should be 1 to 2 mm from therim. If the brake pads are tooclose to the rim, the brake istoo tight. Brake pads shouldbe aligned with the rim surface (Figure 2). If the brakesare not properly adjusted, follow the instructions in the Figure 2- Brake pad alignment Adjustment section of this A: Brake pad aligned with rim surface manual or take your bicycle to B: Brake pad and rim parallelyour dealer for service. C: Brake pad toe-in A B C uSe yOuR BRakeS CaRefuLLy Always keep a safe stopping distance between youand other vehicles or objects. Adjust stopping distances and braking forces to suit riding conditions. do not overuse the front-wheel brake If your bicycle has two hand brakes, apply bothbrakes at the same time. Over-use or misuse of a front- wheel brake, such as using only the front-wheel brakein an emergency, could cause the rear wheel to lift from the ground which could cause you to lose control(Figure 3). Figure 3- Overuse of the front-wheel brake can cause the rear wheel to lift WaRninG applying sudden or excessive stopping force with the fr...