Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
standards when properly installed and used. Glues and Sealants - exercise caution - if these are still in liquid form use face mask and disposable gloves. IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING WARRANTY. Any alteration that is not approved by Aga could Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre, Kerosene invalidate the approval of the appliance, operation of the warranty Oil - may be harmful if inhaled, may be irritating to skin, eyes, nose and could affect your statutory rights. and throat. When handling avoid inhaling and contact with skin or eyes. Use disposable gloves, face-masks and eye protection. After Important handling wash hands and other exposed parts. When disposing of This appliance may contain some of the materials that are indicated. the product, reduce dust with water spray, ensure that parts are It is the Users/Installers responsibility to ensure that the necessary securely wrapped. personal protective clothing is worn when handling, where applicable, the pertinent parts that contain any of the listed materials that could be interpreted as being injurious to health and safety, see below for information. NOTE: AGA GAS FIRED COOKERS ARE DELIVERED INSTALLATION EX-WORKS UNASSEMBLED. ASSEMBLY IS UNDERTAKEN ON SITE BY THE AUTHORISED AGA With specific exceptions, the installing of any type of Aga DISTRIBUTOR. Cooker is subject to the respective directions contained in current issue of The Building Regulations. In addition, Cooker Base or Hearth Planning Permission may need to be obtained, which It is essential that the base or hearth on which the cooker should be applied for separately. The complete range of stands should be level and be capable of supporting the Aga cookers are suitable for Natural or Propane gases total weight of the respective cooker. only and cannot be used on any other gas. Models GC and GCB 406Kg, GE and GEB - 584Kg. The complete cooker is floor-mounted and the space in The top of the hearth must be of non-combustible material which the appliance is to be fitted must have the following thickness of 12mm. minimum dimensions: The wall behind the cooker must be of non-combustible material for a minimum thickness of 25mm. A minimum clearance of 60mm is required above the raised insulating cover handle. Tiling When the cooker is to stand in a recess, or against a wall Side Clearances: A 3mm gap is required each side which is to be tiled, in no circumstances should the tiles between the cooker top plate and adjoining work surfaces overlap the cooker top plate. that maybe fitted, this is to allow for the safe removal of Installation Requirements the top plate should this be required at a later date. The installation of the cooker must be in accordance with the relevant requirements of the Gas Safety Regulations, Where cookers are fitted against side walls a 116mm Building Regulations and the bylaws of the local Water clearance is required at the right hand side for oven doors Undertaking. access. (A further 116mm is necessary if a left hand side It should be in accordance also with any relevant gas connection is required. requirements of the Gas Region and Local Authority. If the Aga is to be installed in a brick recess, then the In you own interest, and that of safety to comply with the minimum clearances should be increased by at least law, all gas appliances should be installed by a competent 10mm on either side, to allow for the walls not being person, in accordance with the relative regulations. square and also for the natural dimensional variations Failure to install appliances correctly could lead to found in the castings. prosecution. On completion, test the gas installation for soundness. In addition a minimum clearance of 1000mm must be available at the front of the cooker to enable the cooker to REMEMBER, when repla...
Эта инструкция также подходит к моделям:Варочные панели - GC (139.78 kb)
Варочные панели - GE (139.78 kb)
Варочные панели - GEB (139.78 kb)