Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Варочные панели - VG295114F/01 (2.66 mb)
Варочные панели - VG295114F/01 (2.28 mb)
Фрагмент инструкции
WP 400 001 multi-layer material wok pan, with The flame setting is infinitely curved base and handle, O 36 cm, variable between high and 6 litres volume, 10 cm high. low. Only use the accessories as specified. The manufacturer accepts no liability if these accessories are used incorrectly. 8 Burner assembly Always assemble the burner par ts correctly and evenly to avoid faults during ignition or during use. The catching pins must fit in the corresponding grooves. Normal burner / high output burner assembly Wok burner assembly Operating principle The gas cooktop features teo normal burners (two flame rings), two high output burners (two flame rings) and a wok burner (three flame rings). The appliance features one-hand operation, automatic fast ignition, electronic flame detection and automatic re-ignition. The ignition is activated when the control knob is turned. The flame size can be set continuously between high and low. Op er at ion The markings show the position of the corresponding burner and the setting between high and low heat. The flame setting is infinitely variable between high and low heat. Notes . Only light a burner if all pan supports and burner parts are properly assembled. . Make sure the burners and electrodes are clean and dr y. . Only use the recommended accessories. Do not cover the stainless steel cooktop base (e. g. with aluminium foil) . . Do not cover the air inlet at the back of the cooktop. Caution! Heat damage to the extractor hood: Always switch on the extractor hood while the gas cooktop is in use. When using several cooking positions select a higher fan level on the extractor hood. Make sure there is a sufficient ventilation of the room. Switching on Your cooktop features automatic fast ignition. 1 Place a suitable pot or pan on the corresponding cooking position. 2 Press down the corresponding control knob and turn it anticlockwise to the required position. The burner lights automatically. The flame size can be set continuously between high and low by slowly turning the control knob. Notes . When using large pots or pans you should ignite the burner in the low position. . Every time the gas hob is switched on, the electronics run an auto test. All electrodes fire and the required burner ignites after a few seconds. When switching on further burners, only the corresponding electrode fires. . When being switched on, a short sound may be heard when the electronic of the gas hob opens the gas supply valve. This is a normal condition. . The cooktop cannot be used during a power failure. Operation indicator The operation indicator next to the control knob comes on, if the burner is switched on and the flame burns correctly. If a malfunction occurs the operation indicator will flash. Electronic flame detection and automatic re- ignition For your safety the cooktop features electronic flame monitoring. Should the flame go out during operation ( e.g. because of a draught) , the appliance will automati...
Эта инструкция также подходит к моделям:Варочные панели - VG295114F/45 (2.34 mb)
Варочные панели - VG295134F/01 (2.34 mb)
Варочные панели - VG295134F/45 (2.34 mb)
Варочные панели - VG295214/01 (2.34 mb)