Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Always dry the burners and pan supports completely. Water droplets or damp patches on the cooktop at the start of cooking may damage the enamel. After cleaning and drying the burners, make sure the burner covers are correctly placed on the burner flame diffuser. Never slide pans across the glass surface, as you may scratch it. In addition, try not to drop heavy or sharp objects on the glass. Never strike any part of the cooktop. Do not use steam cleaners. This could damage the cooktop. Never use abrasive products, steel scourers, sharp implements, knives, etc. to remove bits of hardened food from the hob. If your cooktop is fitted with a glass or aluminium panel, never use a knife, scraper or similar to clean the point where it joins the metal. Do not use knives, scrapers or similar implements to clean the point where the glass meets the burner trims, the metal frames or the glass/aluminium panels, if fitted. Always clean off any liquid as soon as it is spilt: you will save yourself any unnecessary effort. Grains of sand that may come from cleaning fruits and vegetables will scratch the glass surface. Melted sugar, or foods which contain a lot of sugar which may have spilt, should be cleaned off the hotplate immediately, using the glass scraper. Sometimes certain faults detected can be easily resolved. Service Before calling the Service Centre, bear in mind the following advice: Fault Possible cause Solution The general electrical Defective fuse. Check the fuse in the main fuse system is malfunctioning. The automatic safety switch or circuit breaker has tripped. box and change it if it is damaged. Check the main control panel to see if the automatic safety switch or circuit breaker has tripped. The automatic on There may be food or cleaning The space between the ignition function does not work. products stuck between the ignition sparkers and the burners. The burners are wet. The burner covers are not correctly positioned. The appliance is not earthed, is not correctly connected or the earth wire is faulty. sparker and the burner must be clean. Dry the burner covers carefully. Check that the covers are correctly positioned. Contact the electrical installer. The burner flame is not uniform. The burner components are not correctly positioned. The grooves on the burner are dirty. Ensure the components are correctly positioned. Clean the grooves on the diffuser. The flow of gas does not appear normal or no gas comes out. The gas supply is blocked via intermediary valves. If the gas is supplied from a gas cylinder, check that this is not empty. Open all intermediary valves. Change the gas cylinder. The kitchen smells of gas. A gas tap has been left on. There may be a leak in the gas cylinder coupling. Turn off the gas taps. Check that the coupling is sound. The safety valves on one of the burners are not working. The control knob was not held down for long enough. The grooves on the diffuser are dirty. Once the burner is lit, hold the control knob down a few seconds longer. Clean the grooves on the diffuser. Any of the following are considered to be abnormal operation and may require servicing: Yellow tipping of the hob burner flame. Sooting up of cooking utensils. Burners not lighting properly. Gas valves, which are difficult to turn in case the appliance fails to operate correctly, contact the authorised service provider in your area. Wiring diagram A. Switch B. Blue wire C. Brown wire D. Terminal E. Ignition module Neff- Gmb H T69S86N0AU NG LP Test point pressure (kPa) Injectors marks LH RHF RHR CF CR 62/215 47/115 130 70 157 83 130 70 97 53 54,60 44 In compliance with AS/NZS 3100 and AS 4551:2008 Made in Spain GMK10010 N29210 Notes: ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. ................................................................................................. .............................
Эта инструкция также подходит к моделям:Варочные панели - T69S86N0AU/05 (2.02 mb)
Варочные панели - T69S86N0AU/07 (2.02 mb)