Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
In accordance with current regulations, the installation and adaptation of gas systems may only be performed by an officially authorised technician. Check all measurements before proceeding to install your new hob. These instructions are only valid for the countries indicated on the appliance. Refer to the technical instructions to adapt the appliance to the conditions of use for the relevant country. This appliance has been designed for home use only, not for commercial or professional use. This appliance cannot be installed on yachts or in caravans. The warranty will only be valid if the appliance is used for the purpose for which it was designed. This appliance should not be connected to device for extracting combustion products. The appliance should not be exposed to strong draughts, as these may blow the burners out. This appliance leaves the factory set for the gas supply indicated on the characteristics plate. Call the Service Centre this it needs to be altered. Do not tamper inside the appliance. If necessary, call your local Service Centre. Look after these instructions of use and installation so as to be able to produce them should the appliance ever change hands. If your hob is supplied with a glass cover, do not subject it to excessive force. If the glass should become detached from the hob, call the Service Centre immediately for them to repair or replace it. Do not use a damaged appliance. The surfaces on heating and cooking appliances get hot when in use. Be careful. Keep children away from the appliance. Only use your appliance for the preparation of food and never for room-heating purposes. Overheated fat or oil can easily catch fire. Never leave the appliance unattended when cooking food with fat or oil, e.g. chips. Never pour water on burning fat or oil. DANGER OF BURNS! Cover the receptacle to smother the flames and turn the hob off. In the event of a fault, cut the gas and electricity supplies to the appliance. Call our Service Centre to repair the fault. Do not use unstable or uneven-based receptacles on cooking plates or burners. They may accidentally tip over. If a gas supply knob/valve jams, do not force it. Call your official Service Centre immediately for them to repair or replace it. While using your gas hob should avoid draughts and spillages of cold liquids. As these may cause the glass to break. Do not use steam clearing machines to clean the hotplate, as there is risk of electrocution. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Never leave the appliance unattended during operation. The illustrations used in this booklet are only intended as a guide. / $, '01 %,)',% /%22%#+. $3),0/)1 0'')11. ,. '.%,42 5. Your New Hob: Pan support Burner (up to 1,75 kW) Burner (up to 1,75 kW) Burner (up to 1,75 kW) Burner (up to 3 kW) Burner (up to 1,75 kW) Triple flame burner up to 3,3 kW) Pan support Burner (up to 1,75 kW) Electric plate 1500 W Pan support Burner (up to 1,75 kW) Triple flame burner up to 3,6 kW) Burner (up to 1,75 kW) Control knob Pan support Pan support Burner (up to 3 kW) Burner (up to 1 kW) Burner (up to 1,75 kW) Burner (up to 1 kW) Burner (up to 3 kW) Burner (up to 1 kW) Control knob Burner (up to 3 kW) Burner (up to 1 kW) Control knob Burner (up to 3 kW) Burner (up to 1 kW) Control knob Gas burners fig 1. Each control knob indicates which burner it controls. fig 1. To light a burner, push in the knob for the burner you wish to use and turn it in an anti-clockwise direction to the lighting position. Hold the knob at the maximum position for a few seconds until the burner ignites and then release and set the knob to the desired setting. If the burner does not light at the first attempt, repeat the operation. If your hob does not come with any kind of automatic ignition system, then light the burners with a naked flame (cigarette lighter, matches, etc.). If the spark plugs are dirty, then a fault may occur in the ignition system. Keep them completely clean. Clean the spark plugs using a small brush, remembering that the...
Эта инструкция также подходит к моделям:Варочные панели - EP626HB90N/19 (1.32 mb)
Варочные панели - EP626PB90N/01 (1.32 mb)
Варочные панели - EP726QB90N/01 (1.32 mb)
Варочные панели - EP726QB90N/18 (1.32 mb)