|
Фрагмент инструкции
Ordinary household bleach is a good disinfectant and can be used in the humidifier tray and bottle after cleaning. 1) Turn off unit and unplug the cord. 2) Remove the water bottles from the 2 in 1 air purifier & humidifier, empty and place them in a secure location. 3) Locate the two internal spring latches on the bottom center of each side of the cover. Press inward while lifting up on the cover to release the latch. Releasing these latches will allow removal of the top housing. Place the top housing on a flat surface. 4) Remove the air cleaning filter from the inside of the unit. See CLEANING AND REPLACING THE AIR PURIFICATION FILTER. Spring Latches Spring Latches REMOVING SCALE 5) Remove the two evaporative water wicks from the tray allowing excess water to drain into the tray. Rinse the wicks under fresh water only. Do not use soap, detergent, or any other cleaners on the wicks. Leave in the sink to drain. 6) Empty the water from the tray. Fill the water tray and each water bottle with one 8-oz. cup of undiluted white vinegar. Let stand 20 minutes in supported upright position. 7) Swish the vinegar solution in the bottles, wetting all surfaces. Dampen a soft cloth with undiluted white vinegar and wipe out the water tray to remove scale. Do not use abrasive cleaners or cloths. Rinse the water bottles and water tray thoroughly with fresh water to remove dissolved scale and cleaning solution before disinfecting. 8) Clean dust from all interior surfaces with a soft dry brush. Clean the top housing gently with a soft, dry cloth. Never use abrasive cleaners. Inspect the air inlet and outlet grills. Clean the grille vents with a soft, dry cloth or brush if they show accumulated dust. DISINFECTING UNIT 9) Fill the water bottles and water tray with a solution of 1 teaspoon bleach in 1 gallon of water. Let solution stand 20 minutes, swishing every few minutes. Wet all surfaces. 10) Empty water bottles and water tray after 20 minutes. Rinse with water until bleach smell is gone. 11) The outside of the water bottles may be wiped with a soft cloth dampened with fresh water. RE-ASSEMBLY 12) Position the tray with the arrows on the inside of the tray pointing toward you. Replace the wicks into the tray water channel. See CONTROLS AND OPERATION section. Note: Both wicks and air filter must be in position for proper operation of the unit. 13) Replace the air filter in the area between the evaporative wicks. The notches in the black filter frame must be facing the front of the water tray. 14) Pick up the top housing with the control knobs facing toward you. Next, position the top housing directly above the tray lowering it carefully onto the tray and aligning the tray and top housing walls. The top housing latches should snap into the shelf inside the tray and attach firmly to the tray. With the latch on both sides of the cover in place, press down firmly on top of the cover to secure the top housing latches to the tray. Lift the housing slightly to be sure it is attached securely to the base. Failure to do so may result in water damage to your home. 15) Return the unit to its desired location. 16) Refill and replace the water bottles. (Refer to the CONTROLS AND OPERATIONS section.) Under certain conditions, water impurities may accelerate bacteria growth in the water bottle. We recommend using Bemis by Essick Air Bacteria Treatment when the water bottles are filled. Follow directions on the bacteriostat container. 17) Plug the unit in and turn it on. REPLACING EVAPORATIVE WICKS We recommend replacing the wicks at least once a season, more often in hard water areas. When the wicks appear excessively clogged with mineral deposits, discard them and restore your 2 in 1 air purifier & humidifier’s efficiency with new wicks. Model #1040 is the replacement evaporative water wick. (Call 1-800-547-3888 to order.) Only Bemis by Essick Air filters and wicks guarantee the certified output of your 2 in 1 air purifier & humidifier. Use of evaporative wicks or filters other than Bemis by Essick Air evaporative wicks or filters will void your warranty as well as the certification of output and may reduce the efficiency and output of your 2 in 1 air purifier & humidifier. CLEANING AND REPLACING THE AIR CLEANING FILTER (MODEL #1202) The air cleaning filter continuously removes particles and odor as the air in the room is circulated during the normal operation of the 2 in 1 air purifier & humidifier. The pleated white media is an electrostatic charged particulate filter for removing dust and small particles. Over a period of time, all the air in the room passes through and is cleaned by the air filter. Caution: Disconnect power before cleaning or servicing. 1) Turn the unit off and unplug the cord. 2) Remove the water bottles from the 2 in 1 air purifier & humidifier and lay bottles on their backs. 3) Remove the top housing from the tray. See Item 3 "CLEANING THE TRAY." 4) Locate the air filter mounted between the evaporative wicks. Lift ...
Эта инструкция также подходит к моделям:Увлажнители воздуха - DP3 200 (1.42 mb)