Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
Place the top housing on a flat surface. REMOVING SCALE 5) The base, with water in the water channel, may be carried to the sink. Lift the wick from the base allowing excess water to drain into the channel. 6) Rinse the wick under freshwater only. Do not use soap, detergent, or any other cleaners on the wick. Leave in the sink to drain. 7) Empty the water from the base and water bottle. Fill the water channel and water bottle with one 8 oz. cup of undiluted white vinegar. Let stand 20 minutes. 8) Dampen a soft cloth with undiluted white vinegar and wipe out water bottle and water channel to remove scale. Do not use abrasive cleaners or cloths. Rinse the water bottle and water channel thoroughly with fresh water to remove scale and cleaning solution before disinfecting. 9) Clean all interior surfaces with a soft brush. Clean the top housing gently with a soft, dry cloth. Never use abrasive cleaners. Inspect the air inlet and outlet grilles. Clean the grille vents with a soft, dry cloth if they show accumulated dust. DISINFECTING UNIT 10) Fill the water bottle and water channel with 1 teaspoon bleach in 1 gallon of water. Let solution stay 20 minutes, swishing every few minutes. Wet all surfaces. 11) Empty water bottle and water channel after 20 minutes. Rinse with water until bleach smell is gone. Dry with a clean cloth. 12) The outside of the water bottle may be wiped with a soft cloth dampened with fresh water. RE-ASSEMBLY 13) Replace the wick into the base water channel. See CONTROLS AND OPERATION Section. 14) Position the top housing directly above the base. Lower it carefully onto the base and align the base and top housing walls. The top housing should rest on the shelf inside the base and attach firmly to the bottom housing. 15) Replace the air cleaning filter (if included). See REPLACING THE AIR CLEANING FILTER Section. 16) Return the humidifier to its desired location. 17) Refill and replace the water bottle. (Refer to the CONTROLS & OPERATIONS Section). Under certain conditions, water impurities may accelerate bacteria growth in the water bottle. We recommend using Bemis by Essick Air Bacteria Treatment when the water bottle is filled. Follow directions on the bacteriostat. 18) Plug the unit in and turn it on. REPLACING EVAPORATIVE WICK AND AIR FILTER We recommend replacing the wick at least once a season, more often in hard water areas. When the wick appears excessively clogged with mineral deposits, discard it and restore your humidifier's efficiency with a new wick. Model #SGL1040 is the replacement evaporative water wick and model #1052 is the replacement air filter. (Call 1-800547- 3888 to order.) Only Bemis by Essick Air filters guarantee the certified output of your humidifier. Use of evaporative wicks other than Bemis by Essick Air evaporative wicks will void your warranty as well as the certification of output and may reduce the efficiency and output of your humidifier. CLEANING AND REPLACING THE AIR CLEANING FILTER (IF INSTALLED) The air cleaning filter continuously removes particles and odor as the air in the room is circulated during the normal operation of the humidifier. Over a period of time, all the air in the room passes through and is cleaned by the air filter. 1) Turn the unit off and unplug the cord 2) Using both hands, remove the water bottle from the humidifier and place it with the cap up in a secure location. 3) Locate the air filter mounted behind the air inlet grille on the back of the humidifier. The air filter is flexible. Place a finger underneath the bottom edge and lift it out of the tabs in the base. Pull it down and away. 4) Inspect the air filter. This is a two-stage device. The fluffy white media is an electrostatic charged particulate filter for removing dust and small particles. The black inner media is a thick, activated carbon filter for removing odors. 5) A clean filter is important to maintain the output performance. Observe the amount of contaminate on the white electrostatic side of the filter. If there is a visible layer of dust accumulation, the filter should be cleaned or replaced. 6) Replacing the air cleaning filter at least once a humidifying season is recommended. The air filter may be gently cleaned with a soft-bristle brush. Care should be used not to pull apart the bonded area around the edge of the filter. Frequent cleaning will lengthen the life of the air filter. 7) To replace the air filter, slip the top edge into the slot above the inlet grille. Bend the filter outward until the botton flange can be inserted into the slotted tabs in the base. Push on the center of the filter to move it into position against the inside of the inlet grille. Slide the filter left until the angled edge contacts the angled grille wall. The white side of the air cleaning filter faces the exterior of the humidifier. Troubleshooting 1. Unit does not operate at any speed setting: • Polarized cord must be fully inserted in wall outlet.Turn the humidistat control fully...