Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
electrical outlet. Do not use extension cords. If the plug does not fully fit into the outlet, reverse plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 2. Keep the electric cord out of traffic areas. To reduce the risk of fire hazard, never put the electric cord under rugs, near heat registers, radiators, stoves or heaters. 3. Always unplug the unit before moving, cleaning or removing the fan assembly section from the humidifier, or whenever it is not in service. 4. Keep the humidifier clean. 5. Do not put foreign objects inside the humidifier. 6. Do not allow unit to be used as a toy. Close attention is necessary when used by or near children. 7. Never use your humidifier while any part is missing or damaged in any manner. 8. To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt or tip humidifier while unit is running. 9. To reduce the risk of damage to humidifier, unplug when not in use. 10. To reduce the risk of accidental electrical shock, do not touch the cord or controls with wet hands. 11. To reduce the risk of fire, do not use near an open flame such as a candle or other flame source. 12. Note the warning label shown below. WARNING: To reduce risk of fire, electric shock, or injury always unplug before servicing or cleaning. 2 Know Your Humidifier Fan Speed Knob Wick Base Chassis Description E27 000 *Output per 24 hrs 2.7 gallons Capacity of Unit 2 gallons Sq. ft. coverage 640 Fan Speeds 2 Replacement Wick 1044 or 1040† Controls Analog ETL Listed Yes Volts 120 Hertz 60 Watts 60 * Based on an area with average insulation and an 8’ ceiling height. Replacement Parts Available For Purchase Description Part Number Chassis (Entire top portion of unit) 1B71889 Base 1B71891 Knob 1B71892 Wick 1044 or 1040† † We recommend using the higher performance1040 wick as replacement. Parts and accessories may be ordered by calling 1-800-547-3888. Please have model number of humidifier available when calling. 3 How Your Humidifier Works Air is drawn in through Your new Essick Air® Evaporative the vents humidifier is designed to satisfy home in the back humidity requirements through the principle of evaporation of water in the air. Humidified air is Once the wick becomes saturated, air expelled out the front louvers is drawn in, passes through the wick and moisture is absorbed into the air. All evaporation occurs in the humidifier so any residue remains in the wick. This natural process of evaporation creates no white dust like some other humidifiers. Set Up and Location 1) Unpack humidifier from carton and remove all packaging material, wick, etc. from box. 2) Place humidifier on a flat level surface. Position the humidifier where the most humidity is needed or where the most air will be circulated throughout the house such as near a cold air return. If the unit is positioned close to a window, condensation may form on the For Reference Only When Outdoor Recommended Temperature is: Indoor Relative Humidity (RH) is F C -10° -24° 20% 2° -18° 25% 10° -12° 30% 20°* -6°* 35% * or higher window pane. If this occurs the unit should be repositioned in another location. CAUTION: Do NOT position the unit directly in front of a hot air duct or radiator. Do NOT place on soft carpet. We suggest placing the unit on a table or on a bookshelf. NOTE: Due to release of cool, moist air from humidifier, it is best to direct air away from thermostat and hot air registers, and to position humidifier next to an inside wall. Unit should not be placed where cold air from outside walls or warm air from a hot air register blows directly on it. 3) Place the humidifier at least 4 inches from the wall. 4 Filling CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep grille dry at all times. 1) Lift chassis (top section) off base. Position wick in the notch at the back of the base. INSERT WICK HERE LIFT CHASSIS POUR WATER HERE WICK 2) Before replacing the chassis, fill the base with unsoftened water. DO NOT POUR WATER OVER THE ELECTRICAL CHASSIS. Fill the base only through the opening provided (See illustration), to the level marked “MAX FILL” on the center bottom of the base. If water spills on the chassis, it must be allowed to dry completely before turning on the humidifier. If you have only softened water available in your home, you can use it, but you will notice a build up of minerals on the evaporative wicks much sooner. Base capacity is 2.0 gallons. DO NOT OVERFILL. CAUTION: Do not spill water on fan motor. Electrical components must be kept dry. 3) We recommend using only EPA registered bacteriostat treatment such as Essick Air Bacteriostat, Part Number 1970 whenever you refill the humidifier base to eliminate bacterial growth. Add bacteriostat according to the instructions on the bottle. 4) Reposition the chassis on the base and the unit is ready for operation. 5) Plug cord into wall receptacle. 5 Controls and Op...