Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Press the steam (17-18*) release button to release steam. 18* 17 Attention: When ironing on a lower temperature setting “•”. • If the appliance has variable steam control (11*), set the variable steam control to its lowest position . • If the appliance does not have variable steam control, press the steam release button only for a few seconds at a time when ironing at lower temperatures. In both cases, if you ind that water is dripping out of the soleplate, set the temperature selector (16) to a higher position (take care that the garment can be ironed on this heat temperature setting). • At the beginning of each use, it is possible that drops of water will be dispensed alongside steam. Therefore, it is advisable to try the iron on the ironing board or a piece of cloth to start with. Tip : for better ironing results, iron the last strokes without steam to dry the garment. 5 “PulseSteam” function This appliance has a special function for tackling dificult creases. The “PulseSteam” function helps soften stubborn garments like jeans or linen faster. When the steam release button is activated, the steam generator will release three powerful shots of steam so that the steam reaches even deeper into the fabrics. 1. Set the temperature selector (16) on “• • •” 2. Briely press the steam shot button (18*) on the top of the handle. or (model dependent) Press the steam release button (17) on the bottom of the handle two times in quick succession (doubleclick). Remarks: • It is possible to stop the shots of steam by quickly pressing the steam button again. • Some water drops may appear when you use the “PulseSteam” function for the irst time. The water drops will disappear after you have used the function for some time. 6 “Intelligent steam” function (model dependent) This system has intelligent steam control, which, after releasing the steam release button (17), provides a small amount of additional steam. The additional steam can always be stopped by briely pressing the steam release button once again. 7 Ironing without steam Begin ironing but without pressing the steam release button. 8 Vertical steam This can be used to remove creases from hanging clothes, curtains etc. Warning!: • Never direct the steam jet at garments that are being worn. • Never aim the steam at people or animals. 1.Set the temperature control knob to at least the “•••” position. 2. Hold the iron in an upright position 15 cm away from the garment being steamed. 3. You can steam iron curtains and hanging garments (jackets, suits, coats...) by placing the iron in a vertical position and pressing the steam release button (17-18*). 9BOSCH 10 BOSCH 9 Energy saving button (model dependent) If the “Energy saving” button (8*) is switched on, you can save up to 25% of the energy and 40% of the water consumption (*), and still achieve good results when ironing most of your garments. It is advisable to use the normal energy setting only for thick and very wrinkled fabrics. (*) In comparison to the maximum setting. Note: If you work with the “Energy saving” function, the variable steam regulation and temperature regulation can still be used as recommended. 10 Auto shut-off (model dependent) If during ironing, the steam release button (17-18*) on the iron handle is not pressed for a certain length of time (8 minutes), the steam station will automatically switch off. The “auto shut-off” indicator lamp (9) will lash when auto shut-off has been activated. To switch the steam station back on, press the steam release button again. 11 Fabric protection soleplate cover (model dependent) The fabric-protection soleplate cover (21*) is used for steam-ironing delicate garments at maximum temperature without damaging them. Use of the soleplate cover also does away with the need for a cloth to prevent shine on dark materials. It is advisable to irst iron a small section on the inside of the garment to see if it is suitable. To attach the soleplate cover to the iron, place the tip of the iron into the end of the soleplate cover and pull the elastic strap over the lower rear of the iron until it its tightly. To release the soleplate cover, pull the elastic strap and remove the iron. The fabric-protection soleplate cover may be purchased from our customer service or from our website. Accessory code (After-sales) Name of accessory (online shop) 571510 TDZ2045 12 Calc‘n‘Clean Advanced Cleaning the Boiler To extend the life of your steam generator and to prevent any build up of scale, it is essential that you rinse out the scale collector (4) and the boiler after several hours of use. If the water is hard, increase the frequency. Do not use descaling agents for rinsing out the boiler, as they could damage it. Automatic clean warning Indicator lamp (12*) will lash indicating that boiler must be rinsed. 1. Check carefully that the appliance is cold and unplugged for more than 2 hours, and that the water tank (1) is empty. 2. Fix the iron to the stand by inserting the tip of the...
Эта инструкция также подходит к моделям:Утюги - TDS2229GB/02 (2.11 mb)