Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Power cable I. Pilot light G. Pointer F. Max. Water level D. Water tank C. Spray outlet B. Water tank cover A. Steam regulator E. Soleplate N. Beaker* M. Spray button H. Temperature control O. "Clean" button * (* model dependent) 2 Filling the water tank Set the steam regulator (A) to the position and unplug the iron from the mains! 1. Place the iron at an angle of 45° with the point facing upwards. 2. Fill the water tank (D) via the water tank inlet but never above the “max” mark (F). Use only clean water from the tap without mixing anything with it. The addition of other liquids, such as perfume, will damage the appliance. Do not use condensation water from tumble dryers, air conditioners or similar appliances. This appliance has been designed to use normal tap water. To prolong the optimum steam function, mix tap water with distilled water 1:1. If the tap water in your district is very hard, mix tap water with distilled water 1:2. You can inquire about the water hardness with your local water supplier. 45. 8 Spray This can be used to remove stubborn wrinkles. 1. Do not use the spray function with silk as staining may occur. 2. Make sure that there is water in the tank (D). 3. When ironing, press the spray button (M) and water will spray out of the spray outlet (C) onto the garment. 9 After finishing each ironing session 1. Unplug the iron from the mains socket. 2. Set the steam regulator (A) to the position. 3. Slide open the water tank cover (B). 4. Hold the iron with the point facing down and shake it gently until all the water has come out. 5. lf the iron is only slightly soiled, pull out the plug and allow the soleplate to cool down. Wipe the housing and the soleplate with a damp cloth only. lf synthetic cloth melts due to too high temperature on the soleplate, switch off the steam and rub off the residue immediately with a thickly folded, dry cotton cloth. 6. Coil the power cable (J) loosely around the heel of the iron, before storing. 7. Store the iron in an upright position. 10 Self Cleaning The self clean function helps remove lime scale that has built up around the steam valve. This should be performed once every 3 or 4 uses. 1. When the iron is cold, slide the steam regulator (A) between the and positions in quick succession about 3 or 4 times to help loosen any lime scale and clean the valve inside. 2. Heat up the iron. Before starting ironing, hold the iron horizontally over a sink and press the jet of steam button (L) 3 or 4 times. This will help force out any lime scale and dirt deposits through the holes in the soleplate (E). 11 Multiple de-scaling system This range of irons is equipped with the following descaling features “AntiCalc”. A. self-clean Each time you use the steam regulator (A), the “self-clean” system cleans the mechanism of any scale deposits. B. Calc’nclean (Model dependent) The “calc’nclean” function helps to remove scale particles out of the steam chamber. Use this function approximately every 2 weeks, if the water in your area is very hard. 1. Unplug the iron from the mains socket, set the steam regulator (A) to the position and fill the water tank (D) with water. 2. Set the temperature selector to the “max” position and plug in th...
Эта инструкция также подходит к моделям:Утюги - TDA5610GB/01 (585.09 kb)
Утюги - TDA5615GB/01 (585.09 kb)
Утюги - TDA5620GB/01 (585.09 kb)
Утюги - TDA5621GB/01 (585.09 kb)