|
Фрагмент инструкции
FIREPROOF ROLLER COVERING -All models are provided with roller covering in fireproof material. INSULATION OF INDUCTION HEATED PARTS -The cover rear serves to insulate the external ambient from the high temperatures reached by the ironing plate and is lined with a layer of high quality insulating material. PEDAL -The foot pedal control (C) also has a rapid stop function: upon pressing it during working, it moves the heating part away from the roller. Before starting working, control the functioning of main safety devices: finger guard, emergency stop button and pedal. In case one of these devices should not work properly do not start ironing and call immediately a qualified technician. MAINTENANCE Any work on mechanical parts and the electrical system must be carried out by fully qualified personnel. Under normal working conditions, IPSO ironers require a minimum of maintenance. To ensure less friction on the items during the ironing process and to keep the chromed surface of the ironing plate clean, it is advisable the user uses daily "G-SIL", a special product for roller ironing which replaces wax. Spray evenly onto the roller as it rotates. Useful tip spray from under the feed-in wooden table with the ironing plate under pressure and slightly heated (80-90°C). Use the spray as and when necessary. Operations carried out by professionally qualified personnel: make sure that the ironed is disconnected from the mains before carrying out maintenance. The mechanical moving parts require weekly lubrication. The reduction gears are self-lubricating and do not require maintenance. The surface of the roller must be checked weekly to ensure that it is smooth and even along its whole length. Any worn areas can be re-padded with steel wool or the external covering can be replaced. ORIGINAL SPARE PARTS The original spare parts are specially made to fulfil our requirements regarding their manufacture, correspondence to the original components and materials used and are therefore ideal for our ironers. To order spare parts, provide the following details: 1) the name of the machine - see data on the rathing plate 2) the serial number - see data on the rathing plate 3) the code of spare part - see spare parts list 4) the quantity required. REPLACING THE ROLLER COVERING 1. Remove the cover sheet and flannel. Wind off the steelwool, completely exposing the roller. 2. Take a new roll of steelwool, cut one and off diagonally and place on the left-hand side of the roller with a slope of approx. 30 degrees. Keep tight. 3. Begin winding towards the right-hand end with the ironing plate under pressure, taking care not to overlap the edges; then take a second layer from right to left in the same way. Repeat this operation until the circumference of the roller reaches 770 mm. 4. Spread the flannel evenly over the padded roller and tighten with the ironing plate under pressure until it is fully wound. Raise the temperature to approx. 130°C and let the roller rotate for a few minutes until the flannel cover is settled. 5. Place the narrowest end of the cover sheet approx. 10 cm under the edge of the flannel, making sure it is perfectly smooth and parallel. Put the ironing plate under pressure and wind the sheet round. Let the roller rotate for a few minutes. When the cover sheet is settled, secure the ends. Ever...
Эта инструкция также подходит к моделям:Утюги - RI1400/25 AV (654.41 kb)
Утюги - RI1400/25 AVL (654.41 kb)