Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
Утюг должен всегда находиться в движении. Шелк и синтетические ткани необходимо гладить с изнаночной стороны. Во избежание появления пятен не увлажняйте такие ткани. УВЛАЖНЕНИЕ При любой температуре глажения для смачивания ткани водой нужно нажать кнопку увлажнения (8). Иногда необходимо нажать кнопку несколько раз. При этом в резервуаре должна находиться вода. ГЛАЖЕНИЕ БЕЗ ПАРА Включите прибор в сеть. 14 ENGLISH 4. To select the temperature setting according to the recommendation of the garment label, depresses the control button. See "How To Set Temperature". 5. When the required temperature reached; the "Indicator lights" will be gone and beep twice. 6. The iron is now ready to use. 7. To switch off the appliance, depress and hold the control button for 2 sec. The LCD will go blank with a long beep and "Indicator lights" will flash on the LCD display. 8. Disconnect the iron from mains supply outlet. 9. When the iron gets cool completely, store it vertically in a safe place. STEAM IRONING 1. Fill the iron as described in "How To Fill Water". 2. Connect the iron to a suitable mains supply outlet 3. The LCD light up for a second and one beep can be heard. 4. "Indicator lights" will flash on LCD. 5. Select the temperature setting to 2-dot, 3-dots or MAX (see How To Set Temperature) 6. When the required temperature is reached; the "Indicator lights" will be gone and has beep twice. 7. Rotate the Variable Steam / Self-Cleaning Knob to give the desired amount of steam. 8. The iron is now ready to use. 9. To switch off the appliance, depress and hold the control button for 2 second. The LCD will black and "Indicator lights" will flash on the LCD display. 10. Disconnect the iron from mains supply outlet. 11. When the iron gets cool completely, store it vertically in a safe place. 7 1221.qxd 01.12.03 15:42 Page 16 ENGLISH Note: Set the Steam Control Knob to this position after use: X BURST OF STEAM This function provides extra amount of steam to remove stubborn wrinkles. 1. Fill the iron as described in the section of Flow To Fill Water. 2. Select the temperature to •' (3 dots) or "Max" setting , by press the control knob (See Flow To Set Temperature). 3. The "Indicator lights" will be gone when the temperature reached and beep twice. 4. The iron is ready for use. 5. Press the Burst Of Steam Button. 6. Steam will shoot from the holes of the soleplate into the fabric being ironed and removing the wrinkles. 7. For stubborn wrinkles, wait a few seconds before pressing the Burst Of Steam Button again. Most wrinkles can be removed within three presses. Note: It may be necessary to press the burst of steam button a few times to start this function. For optimum steam quality, do not operate the Burst Of Steam more than three times after the pilot light goes off. BURST OF STEAM IN VERTICAL POSITION Warning: Do not apply steam on any clothes or fabrics that are being worn by human or pets. Temperature of steam is very...