|
Фрагмент инструкции
If you have extremely hard water, we recommend to use a mixtur of 50 % tap water and 50 % distilled water. Fill the water tank to «max» marking. Never use distilled water exclusively. Do not add any additives (e.g. starch). • Keep the iron in the upright position and connect it to the mains. Select the temperature according to the ironing guide on the heel rest of the iron or on the label in your garments. • The pilot light goes off when the desired temperature is reached (after approx. 1 o min.). C Ironing Vario steam You can increase and reduce the quantity of steam by turning the steam regulator. The steam regulator and the temperature selector have to be set within the red range. Notice: While ironing, do not turn the steam regulator beyond the red range. For power shot and vario plus steam, the temperature selector must be set within the continuous red range. These functions can even be activated when dry ironing. We recommend a medium steam setting for all normal ironing. Only when ironing linen, thick cotton or similar fabrics we recommend the maximum steam setting. Vario plus (model 3240 only) Press the steam plus button (6) for max. 3 seconds, but not more often than 4 times per minute. Power shot Press the power shot button (3) in intervals of at least 5 seconds. Spray function Press the spray button (4). Dry ironing Set the steam regulator (5) on position «0» (= steam off). Notice: Prior to ironing, press the power shot button 3 to 4 times to activate them. This function can be used for steaming hanging clothes. D After ironing Unplug the iron. To prolong the life of the iron, empty the water tank. Store the cool iron in a dry place always standing on its heel rest. E Maintenance and cleaning To clean the sole plate, use steel wool. Never use a scouring pad, vinegar or other chemicals. F Cleaning the anticalc valve The anticalc valve on the steam regulator has to be decalcified regularly (e.g. whenever steam development is insufficient). For this, the water tank has to be empty. Removing the steam regulator with the anticalc valve Turn the steam regulator clockwise to the double arrow at the end of the anticalc section and it will lift. Pull it out vertically. Do not touch the anticalc valve at its lower end. Immerse the anticalc valve in vinegar (not vinegar essence) or lemon juice for minimum 30 minutes. Brush off remaining residues and rinse under running water (fig. F 1-5). Re-inserting the steam regulator To re-insert the steam regulator follow fig. 6 and 7. Notice: The iron must not be used without the steam regulator. G Decalcifying/anticalc system In order to clean the steam chamber from residues, decalcify it as shown in fig. G 1-11. Caution: Hot water and steam will come out from the sole plate when the steam regulator is turned clockwise into the anticalc area. Wait for the sole plate to cool down, then clean it as described above. Then refill the tank with water, heat up the iron and press the power shot button 4 times to r...
Эта инструкция также подходит к моделям:Утюги - SI 3120 (1.37 mb)
Утюги - SI 3230 (1.37 mb)