Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
The temperature selector (6) has to be set within the red range (between «••» and «max»). Preconditioning (only with model SI 2040) Steam also develops horizontally at the front area of the sole plate. This preconditions the textiles by «pre-steaming», thus making ironing easier. Be careful – steam comes out laterally. 2 Power shot Prior to use, press the Power shot button (5) 3 to 4 times to activate it. Press the Power shot button in intervals of at least 5 seconds. Power shot can be activated when dry ironing. The temperature selector has to be within the solid red range (between «•••» and «max»). Models SI 2030 and SI 2040 only: The Power shot function can also be used in the vertical position for steaming hanging clothes. 3 Spray function Press the spray button (4). 4 Dry ironing Set the steam regulator (3) on position «0» (= steam off). D After ironing Unplug the iron and turn the steam regulator to position «0». To prolong the life of the iron, empty the water tank. Store the cool iron in a dry place always standing on its heel rest. E Maintenance and cleaning To prevent damaging the sole plate, do not iron over metal buttons or zippers. Clean the sole plate regularly with a damp cloth. To remove mineral/starch residues, use a vinegar/water mixture in the ratio of 1:2. Never use steel wool, abrasive scouring pads, powders or other chemicals to clean the sole plate. F Cleaning the anticalc valve The anticalc valve located on the lower end of the steam regulator (3) has to be decalcified regularly (e.g. whenever steam development is insufficient). For this, the water tank has to be empty. Removing the steam regulator with the anticalc valve: Turn the steam regulator clockwise towards . Keep on turning firmly beyond the resistance until the steam regulator is lifted. When positioned at «•» (anticalc system), pull it out vertically. Do not touch the anticalc valve at its lower end. Immerse the anticalc valve in vinegar (not vinegar essence) or lemon juice for a minimum of 30 minutes. Brush off remaining residues and rinse under running water (fig. F 1–5). Re-inserting the steam regulator: When re-inserting the steam regulator, make sure the steam regulator base still points on setting «•» (anticalc system) (fig. F 6). When firmly pushing down the steam regulator, it turns back to (fig. F 7) where it catches. Notice: The iron must never be used without steam regulator. G Decalcifying / anticalc system In order to clean the steam chamber from residues, decalcify it as shown in picture section G 1–11. Caution: Hot water and steam will come out from the sole plate when the steam regulator is turned clockwise beyond . Wait for the sole plate to cool down, then clean it as described above. Then refill the tank with water, heat up the iron and press the Power shot button four times to rinse the iron before ironing (fig. G 12–14). Do not use commercial decalcifiers, they may damage the iron. Trouble-shooting guide Problem Remedy Drops coming out of Tu...
Эта инструкция также подходит к моделям:Утюги - EasyStyle SI 2010 (1.49 mb)
Утюги - EasyStyle SI 2030 (1.49 mb)
Утюги - EasyStyle SI 2040 (1.49 mb)