Войти:
Оценок - 4, средний балл: 3.8 ( )

Инструкция по эксплуатации Groupe SEB USA - T-FAL, модель PROTECT TURBO

Производитель: Groupe SEB USA - T-FAL
Размер: 479.57 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


3. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. 4. Unscrew the cord clip by turning a quarter turn to the left (18). 5. Using a coin, gently unscrew the boiler rinse plug (19). 6. Place the plastic nozzle of the rinsing pipe into the hole of the boiler and turn gently to the right until it locks. The outlet of this nozzle must be positioned over the sink (20). 7. Connect the rubber end of the rinsing pipe to a cold tap (21). 8. Turn the tap on gently and gradually and let cold water run through the rinsing pipe into the sink for about 1 minute (22). 9. Switch off the tap and remove the rinsing pipe. 10. Screw back and tighten up the boiler rinse plug with a coin. 11. Put the cord clip back in place. 12. The next time you use the generator, hold down the “reset” button for 2 to 3 seconds to turn off the orange light. 18 19 20 21 22 1 2 1I.TO RINSE THE BOILER WITHOUT THE RINSING ACCESSORY Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for at least 2 hours in order to avoid any risk of scalding. If the orange “boiler rinse” light flashes, you can continue ironing normally but remember to rinse the boiler first, the next time that you use it. 1. Check that the generator is cold and unplugged. 2. The protective hood must be folded down over the tank. 3. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. 4. Unscrew the cord clip by turning a quarter turn to the left. 5. Using a coin, gently unscrew the boiler rinse plug. 6. Holding your steam generator in a tilted position, and using a jug, fill the boiler (in the base unit) with 1/4 litre of tap water. 7. Shake the base unit for a few moments and then empty it completely over your sink. To obtain the best result, we recommend that this operation is done twice. 8. Screw back and tighten up the boiler rinse plug with a coin. 9. Put the cord clip back in place. 10. The next time you use the generator, hold down the “reset” button for 2 to 3 seconds to turn off the orange light. 12- PUTTING YOUR STEAM GENERATOR AWAY 1. Place the iron on the rest. 2.Turn off at the main O/I switch and unplug. 3. Raise the 2 parts of the hood over the iron until the protection system locks into place (audible click) (23). 4. Retract the electric supply cord (24). On the model with an automatic reel, press the reel button and guide the cord with your free hand. 5. Store the steam cord by wrapping it around the casing and securing it in its retaining clip. 6. You can then put your steam generator away, carrying it by the handle (25). CLICK232425 13- SAFETY RECOMMENDATIONS • Your steam generator is an electrical appliance. It should be used under normal conditions. It is intended for domestic use only. • Your generator is fitted with 2 safety systems : -A pressure release valve which, in the event of a malfunction, releases any excess steam. -A thermal fuse to prevent the appliance from overheating. • This appliance is not intended to be used by children or without supervision by persons whose physical, sensory or mental aptitude to use it in complete safety is impaired. Children must be supervised to ensure that they do not play with the appliance. • The appliance must be used and placed on a stable, heat-resistant surface. • Completely unwind the power cord from its storage space before connecting to an earthed socket. • Always plug your steam generator into: -An electrical installation with voltage between 220V and 240V. Connecting to the wrong voltage may cause irreparable damage to the appliance and will invalidate your guarantee. -An earthed socket. If you are using a mains extension lead, ensure that it is correctly rated (10A) with an earth, and is fully extended. • Should the power cord or the boiler cord linking the iron to the base unit become damaged, it must be replaced by a TEFAL approved service centre to avoid the risk of danger or injury. Be careful: • The soleplate and generator iron-rest can become very hot and cause burns : never touch these parts. • If you store your iron in a cupboard or confined space, ensure that it is left to cool before putting it away. •Your appliance gives off steam which can cause burns. • Handle your iron carefully, particularly when using the vertical steam function • Never direct the steam towards persons or animals. • Never touch the electric cords with the sole plate of the iron. • Never leave the appliance unattended : -when it is connected to the mains, - until it has cooled down (around 1 hour). • Do not unplug the appliance by pulling on the cord. • Always unplug your appliance : - before rinsing out the boiler, - before cleaning your generator, - after each use. • Before unscrewing the boiler rinse plug, wait until the generator is cold (unplugged for more than 2 hours). • Never fill the boiler through the rinse hole (except for rinsing) • Never immerse your steam generator in wate...

Эта инструкция также подходит к моделям:
Утюги - PROTECT (479.57 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории