Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
This happens as the steam chamber becomes conditioned. This will stop after a few uses. • During first use of the iron, it may appear to smoke. This will stop and does not indicate a defect or hazard. 840094100 ENv01 1/17/02 11:46 AM Page 3 Parts and Features 1. Removable Reservoir Release Button 2. Spray/Blast Buttons 3. Adjustable Steam Switch 4. Water Tank Opening 5. Spray Nozzle 6. Removable Reservoir 7. Self-Clean Button 8. Temperature Control Dial 9. Soleplate 10. Automatic Shutoff Reset Button/ Power On Light 11. Heel 12. Cord Fabric Setting Chart Steam Setting Temperature Setting Ironing Instructions O DryIronNylon Dry iron using spray if necessary. Silk, Acrylic Dry iron on the wrong side of the fabric. Steam Range Wool Use a press cloth and steam iron on the wrong side of fabric. Polyester Iron while fabric is still damp. Rayon Iron using spray if necessary. Cotton, Linen For cotton, iron while still damp or use spray. For linen, iron fabric on wrong side. 3 840094100 ENv01 1/17/02 11:46 AM Page 4 Using Your Iron To Dry Iron 1. Plug iron into outlet. 2. Set the Adjustable Steam Switch to O (the Dry Iron position) or empty water from reservoir. To Steam Iron 3. Turn Temperature Control Dial to desired temperature. Allow two minutes for iron to reach desired temperature. 4. To turn iron Off, turn Temperature Control Dial to Off and unplug iron. 1. Unplug iron. Fill Removable Reservoir according to directions. Replace Reservoir. 2. Plug iron into outlet. 3. Turn the Temperature Control Dial to desired fabric setting in the steam range. Set the Adjustable Steam Switch to the recommended steam level. See “Fabric Setting Chart” on page 3. 4. Allow 2 minutes for the iron to reach desired temperature. 5. To turn iron off, set Adjustable Steam Knob to O (Dry Iron). Turn the Temperature Control Dial to Off. Unplug iron. 6. Empty water from the iron following directions in “Caring for Your Iron.” Water Please use ordinary tap water. If you have extremely hard water, alternate between tap water and distilled water for use in the iron. To Remove, Fill, and Replace Reservoir NOTE: The reservoir can be filled in place or removed for filling. 1. Unplug iron. Set the Adjustable Steam Switch to O (Dry Iron). 2. Press and hold release button and pull straight up on reservoir. Use caution and do not let your hand touch the hot soleplate. 3. Slide open reservoir fill opening cover. Slowly pour in 4 ounces of water. Close cover. 4. Firmly place reservoir in position and push until it snaps back into place. 5. Reset the Adjustable Steam Switch to desired steam level. 4 840094100 ENv01 1/17/02 11:46 AM Page 5 To Vertical Steam 1. Unplug iron. Fill the Removable Reservoir according to directions. Replace Reservoir. 2. Plug iron into outlet. 3. Turn the Temperature Control Dial to the highest setting. 4. Allow 2 minutes for the iron to reach desired temperature. 5. Hang garment in a location that is not susceptible to damage from heat or moisture. Do not hang in front of wallpaper, window, or mirror. 6. Hold iron about 6 inches away from garment and press and release the Blast Button to steam out wrinkles. Do not press Blast Button more than once every 2 seconds. 7. To turn iron off, turn Temperature Control Dial to Off. Unplug iron. 8. Empty water from the iron following directions in “Caring for Your Iron.” NOTE: Do not allow hot soleplate to touch delicate garments. Optional Features (on selected models) Adjustable Steam Knob This switch provides minimum steam for wool or maximum steam for linen. Set the switch to O to change to Dry Iron. Spray and Blast of Steam Buttons Push Blast Button for an extra blast of steam. Push Spray Button to release a fine spray of water for difficult wrinkles in cotton or linen. Blast Spray Automatic Shutoff Reset Button and Power On Reset Light – The Button Automatic Shutoff Reset Button light comes on when the iron is first Power plugged in. After Light 1 hour, the iron will shut off and the light will go out. Push the Reset Button to turn iron back on. The Power On Light comes on when the iron is plugged in and remains on until the iron is unplugged. The light stays on even if Temperature Control Dial is turned to Off. 5 840094100 ENv01 1/17/02 11:46 AM Page 6 Self-Clean To keep the steam vents clear of any build-up, follow these instructions after each time you use the iron using steam. 1. Fill Removable Reservoir according to directions. Replace Reservoir. 2. Plug iron into outlet. 3. Turn Temperature Control Dial to Linen setting and let iron heat for two minutes. 4. Turn Temperature Control Dial to Off. Unplug iron and hold over a sink with the soleplate facing down. 5. Set Adjustable Steam Switch to (Maximum Steam). Press and hold the Self-Clean button until all water has drained from the iron. 6. Allow all water to drain from iron, then let cool and store. Caring for Your Iron Iron 1. The Removable Reservoir of your iron should be emptied after each use. Turn Temperature Control D...