Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Устройства обработки данных - HP EVA6400 Array (246.83 kb)
Устройства обработки данных - HP EVA6400 Array (173.83 kb)
Устройства обработки данных - HP EVA6400 Array (156.81 kb)
Фрагмент инструкции
HP StorageWorks
About this document
power UID replacement
For the latest documentation, go to http://www.hp.com/support/
manuals, and select your product.
instructions
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website: http://www.hp.com/
go/storagewarranty
These instructions apply to the MSA6X/7X, Proliant
Before you begin
DL320S, EVA4400, EVA6400, and EVA8400 product
families.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
Verifying component failure
Improper or failed operation of the LEDs on the power UID may indicate
a replacement is necessary.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
Proper LED operation for the MSA6X/7X is displayed as:
Second edition: February 2009
• Blue = Identified
The information in this document is subject to change without notice.
• Blue flashing = Active remote management
• Off = No active remote management
Printed in Puerto Rico
Proper LED operation for the EVA is displayed as:
www.hp.com
•
= Enclosure external health (controller enclosure only). Solid
green indicates the enclosure is powered on. Blinking green indicates
a power off has been initiated by holding down the power button
for 4 to 5 seconds.
•
= Enclosure external health (disk enclosure only). Solid green
indicates the enclosure is operating normally. Blinking green indicates
power up.
•
= Enclosure fault warning. Flashing amber indicates a fault of
lesser importance, while solid amber indicates a fault of greater im-
portance.
•
= Unit identification. Push switch to illuminate solid blue; push
again to turn off. The UID mimics the status of the UID at the front of
the enclosure. A remote session from the management card or HP
Command View EVA can also illuminate the LED.
•
= Bi-color On/Standby button switch. Green indicates power
is applied and amber indicates standby power.
*533484-001*
Page 1
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP EVA6400 for Storage Centric Rack (1.23 mb)
Устройства обработки данных - HP EVA8400 Array (1.23 mb)