Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
HP StorageWorks
Warranty Information
If the product in which this part is being replaced is stil under
Controller Blower Replacement
HP warranty, then the replacement part(s) referred to in these
Replacement Instructions is provided under the terms and conditions
Instructions
of the Hewlett-Packard Company Limited Warranty for that
product. A copy of this Limited Warranty may be viewed at:
ht p://h18006.www1.hp.com/products/storageworks/warranty.html
If this is a trade sale part (product out of warranty), then the replacement
part(s) referred to in these Replacement Instructions is provided under
HP's express limited warranty statement, which may be viewed at:
ht p://customerops.corp.hp.com/1sw/pdm_om/warranty_support/
policies/2330100.doc
The replacement part takes on either the Limited Warranty Period of the
part being replaced or a ninety-day period that begins upon installation
of the replacement part, whichever is greater.
The only warranty for this replacement product is as noted above.
Nothing in these replacement instructions should be construed as
constituting an additional warranty. The information provided in these
replacement instructions is provided "AS IS" and HP is not liable for
These instructions apply to the EVA
technical or editorial errors or omissions contained herein.
4000/6000/8000 product family. The part
may also be used in other HP products. Please refer to
documentation for your specific product for detailed
About This Document
replacement instructions.
This document describes the procedure for replacing the blower used in
Enterprise Virtual Array 4000/6000/8000 products.
Printed on at least 50% total recycled fiber with at least
Before you begin
10% post-consumer paper.
Observe the following precautions when replacing a battery.
CAUTION:
© Copyright 2005 Hewlet -Packard Development Company, L.P.
Removing a blower significantly changes the air flow within the
enclosure. Both blowers must be installed for the enclosure
Second edition March 2006
to cool properly. If a blowers fails, leave it in place in the
enclosure until a new blower is available to install.
Product names mentioned herein may be trademarks of their
respective companies as reflected by an associated footnote.
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
The information in this document is subject to change without
with your system for additional information.
notice.
Have a copy of the product User Guide available for reference.
Printed in the U.S.A.
You can download a copy of the User Guide from the product
support page on the HP web site.
www.hp.com
Verifying component failure
Before replacing a blower, use the fol owing methods to verify the
component failure:
CAUTION:
If Command View EVA does not present a status consistent with
that of the blower status indicators, or if Command View or the
System Event Analyzer indicates multiple hardware failures,
contact HP support for assistance. The HP support web site is
.
located at ht p://www.hp.com/support
*5697-5246*
Page 1
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP EVA4000/6000/8000 Disk Arrays (98.9 kb)
Устройства обработки данных - HP StorageWorks EVA4000 SAN Starter Kit (98.9 kb)
Устройства обработки данных - HP StorageWorks EVA4000 Starter Bundle (98.9 kb)
Устройства обработки данных - HP EVA4100 Starter Kit (98.9 kb)