Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• Please keep this instruction sheet for future reference, as it contains important information. • Requires three button cell (LR44) batteries for operation (included). • Tool required for battery removal: Phillips screwdriver (not included). ICES-003 This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. NMB-003 Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. L’utilisation de ce dispositif est autorisee seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit etre pret a accepter tout brouillage radioelectrique recu, meme si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help. Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. 2 3 Assembled Parts Hub 3 Tubes Quilt Quilt • Wash the quilt in cold water on the gentle cycle. Do not use bleach. Tumble dry low. Tubes, Hub and Toys • Wipe the surface with a clean cloth dampened with a mild soap and water solution. Do not use bleach. • Do not immerse the monkey toy. Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. P5333pr-0920 ©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA 4 5 • Insert and snap the tubes into the hub. Setup 1 21 • Lay the quilt out on a flat surface with the decorated side up. • Fit the end of each tube through the large loops on the quilt. Make sure the loop is fitted below the tab on each tube. Tube Quilt Large Loop Hub Tube Tab • Hang the toys from any of the loops around the gym. • Spin the roller on the monkey for musical tunes and fun sounds. 6 7 21 • Push the button on top of the hub and remove each tube. 1 Storage • Place the tubes, hub and toys near the top of the quilt. • Roll the quilt, as shown. 31 • Slide one storage strap through the loop. • Tie the storage straps to hold the quilt in place. 41 Hub Tube Loop Storage Strap Large Carry Loop Battery Replacement Battery Safety Information 1.5V x 3 LR44 or Equivalent • Locate the battery compartment on the back of the toy. • Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door, and throw exhausted batteries away. • Insert three, new, button cell (LR44) alkaline batteries, as indicated inside the battery compartment. • Replace the battery compartment door and tighten the screws with a Phillips screwdriver. Do not over-tighten. • If this toy begins to operate erratically, you may need to reset the electronics. Remove the batteries and replace them back in the toy. • When sounds from this toy become faint or stop, it is time for an adult to change the batteries! • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only). In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of product in a fire. The batter...