Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
To turn on the power, press the console button or simply begin pedaling. When the power is turned on, the entire display will appear for two seconds. The console will then be ready for operation. 2. Select one of the five modes: Scan modeN Mode Indicators When the power is turned on, the scan mode will automatically be selected. One mode indicator will show that the scan mode is selected, and a flashing mode indicator will show which mode is currently displayed. Note: If a different mode is selected, you can select the scan mode again by repeatedly pressing the console button. Speed, time, distance or calorie modeN To select one of these modes for continuous display, press the console button repeatedly. The mode indicators will show which mode is selected. Make sure that the scan mode is not selected. 3. To reset the display, hold down the console button for two seconds. After the display is reset, the scan mode will be selected. 4. To turn off the power, simply wait for about four minutes. Note: The console has an Oauto-offO feature. If the pedals are not moved and the console button is not pressed for four minutes, the power will turn off automatically in order to conserve the batteries. 7 MAINTENANCE AND TROUBLE-SHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. The exercise cycle can be cleaned with a soft, damp cloth. Avoid spilling liquid on the console. Keep the console out of direct sunlight or the display may be damaged. Remove the batteries when storing the exercise cycle. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. See assembly step 4 on page 5. In addition, make sure that the console wire is plugged into the console. HOW TO TIGHTEN THE CRANK If the arms of the crank become loose, they should be tightened in Crank SlottedCrankNutCrank Arm order to pre- Nut vent excessive wear. Loosen the crank nut on the left arm of the crank. Place the end of a standard screwdriver in one of the slots in the slotted crank nut. Lightly tap the screwdriver with a hammer to turn the slotted crank nut counterclockwise until the arms are no longer loose. Do not overtighten the slotted crank nut. When the slotted crank nut is properly tightened, retighten the crank nut. HOW TO ADJUST THE RESISTANCE STRAP If there is not enough pedaling resistance when the resistance knob is turned to the highest setting, the resistance strap may need to be adjusted. To adjust the resistance strap, first turn the resistance knob to the lowest setting. Next, locate the slotted tab on the front of the exercise cycle. Grip the main part the resistance strap underneath the slotted tab and pull it towards the slot. When a little slack is created, pull the end of the resistance strap tight and then let go of the strap. Turn the crank for a moment to make sure that there is not too much resistance. Slotted Tab Resistance Strap HOW TO ADJUST THE CHAIN The exercise cycle feat...
Эта инструкция также подходит к моделям:Тренажеры - 831.288140 (324.03 kb)
Тренажеры - 831.288140 (324.03 kb)
Тренажеры - 831.288140 (324.03 kb)
Тренажеры - 831.288140 (324.03 kb)