Оценок - 5, средний балл: 4.4
(
)
)
|
Фрагмент инструкции
The convenient hand control allows you to choose upper-back, lower- back or whole-back massage. You can also choose between six massage programs. For your benefit, read this manual carefully before using the massage chair. If you have additional questions, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please note the product model number and serial number before calling. The model number is 831.219910. The serial number can be found on a decal attached to the massage chair (see the front cover of this manual for the location). Before assembling the massage chair, please look at the drawing below and familiarize yourself with the parts that are labeled. Cover Pad Footrest Hand Control Hand Control Holder (On both sides) Headrest Armrest Armrest On/off Switch Circuit Breaker Power Cord (On the back) Recline Control Footrest Control Arm (On right side) 5 6 1. Feed the Recline Shock (20) and the attached cable between the tubes on the Base (1). See the inset drawing. Remove the rubber bands from the screws in the Base (1). Be sure that the Arm Brackets (31) inside the tubes on the Base are pressed against the indicated sides of the tubes. Align the posts on the Right Armrest (5) with the tubes on the Base (1). Slide the Right Armrest onto the Base. Make sure the posts go inside the tubes on the Base. Make sure the cable is between the posts. Note: You may need to flex the posts away from the Right Side Shield (7) to assemble it past the Bracket Screws (see step 4) in the Base. 2. Tip the chair onto its right side. Remove the shipping bracket from the Seat Frame (2) and the Back Frame (4) by removing the Cotter Pins (26) and Hairpin Cotters (27). Save the Cotter Pins and Hairpin Cotters; you will need them for step 3. 3. Attach the indicated end of the Recline Shock (20) to the Back Frame (4) with a Cotter Pin (26) and a Hairpin Cotter (27). Attach the other end of the Recline Shock (20) to the Seat Frame (2) with a Cotter Pin (26) and a Hairpin Cotter (27). Make sure the cable is under the Recline Shock, as shown in the drawing. Note: You may need to raise the Back Frame (4) to the upright position in order to attach the Recline Shock. Lift the chair back onto its Base. 2 27 Shipping Bracket 2 4 27 26 26 Place all parts of the massage chair in a cleared area and remove the packing materials. Do not dispose of the packing materials until the massage chair is fully assembled. Assembly requires only the included allen wrench. ASSEMBLY 27 2 4 27 26 26 20 1 5 7 Posts 1 20 3 31 1 31 Top View 4. See the inset drawing. Remove the rubber bands from the screws. Be sure that the Arm Brackets (31) inside the tubes on the left side of the Base (1) are pressed against the indicated sides of the tubes. Align the posts on the Left Armrest (6) with the tubes on the Base (1). Slide the Left Armrest onto the Base. You may need to flex the pos...
Эта инструкция также подходит к моделям:Тренажеры - 831.219910 (800.52 kb)
Тренажеры - 831.219910 (800.52 kb)
Тренажеры - 831.219910 (800.52 kb)
Тренажеры - 831.219910 (800.52 kb)