Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
TO APPLY LUBRICANT TO THE WALKING BOARD 1.) Take foam wand applicator, without lube, and insert it in between the walking belt and deck, exposing the two plastic tabs at either end of the walking belt. Take both tabs and run the wand back and fort along the entire length of your deck. Remove the applicator and prepare for lubrication. 2) Apply about a dime’s worth of lubrication onto the side of the applicator wand hat was not used for removing dirt and debris (step 1). You can add more or less lubricant, depending on your lubrication schedule. 3) Insert the wand between the walking belt and deck, exposing the two white plastic tabs at either end of the walking belt. 4) Take both of the tabs and run the wand back and forth along the entire length of your deck. You are done until your next scheduled lubrication date. 5) Allow the silicone to ‘set’ for one minute before using the treadmill. WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a clean towel. Maintenance Instruction To avoid possible damage to the treadmill and the possibility of injury, do not operate the treadmill until the problem is corrected. Call Ironman Fitness Customer Service at (800) 750-4766 Troubleshooting Guide Treadmill will not start. 1. Is the Safety Key inserted into the treadmill Console? 2. Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet, and the surge protector is turned on. (Refer to “Power Requirements” on page 17.) 3. Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it has tripped. Wait five minutes and then press the switch back in. 4. Check the house electrical breaker box and the circuit breaker for the room where the treadmill is located. If it has tripped, reset or have an electrician replace the breaker in home. 5. Have an electrician check to insure there is adequate voltage at the outlet. Treadmill loses power during use. 1. Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it has tripped. Wait five minutes and then press the switch back in. 2. Check the house electrical breaker box and the circuit breaker for the room where the treadmill is located. If it has tripped, reset or have an electrician replace the breaker in home. 3. If the treadmill will not operate, please call Ironman Fitness Customer Service at (see number above). Treadmill walking belt slows during use. 1. Check to make sure the treadmill is securely plugged into an UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less and the surge protector is securely plugged into the outlet. 2. If treadmill will not operate, please call Ironman Fitness Customer Service at (see number above). Treadmill walking belt slips or is not centered on rear roller. 1. Refer to “Belt Adjustment” section on page 34 . 2. Need help? Call Ironman Fitness Customer Service at (see number above). Treadmill belt is making noise Treadmill belt may develop “belt memory” where the rollers are located due to packaging and storage. The noise goes away once the belt has been stretched out properly from regular use. Treadmill Error Messages. Your treadmill is equipped with a software package that enables error messages to be displayed when there is a problem. Treadmill Belt Reminder. After 30 hours of use, the console will remind you to lubricate your belt. Troubleshooting guide Parts Information 37 2345718914114415467461194117478136486123602851454364613121634352224252630313233373839404241492952535457595962636466667271607677 7882841051131271317311419058556910566667717527355050597070721289212612421212010610710813311111211711611889917980889010110210985 38 Exploded View 103108116107106111133117118112 Exploded View ReferencePart NumberDescriptionQtyReferencePart NumberDescriptionQty1100422MOUNT, CONSOLE BRACKET155100393PHILLIPS SCREW, M6X1552-UPRIGHT FRAME, MAIN156100072PHILLIPS SCREW, M6X3023100423HANDLEBAR, LEFT IM TREADS FY09157100073PHILLIPS SCREW, M5X1084100424HANDLEBAR, RIGHT IM TREADS FY09158100394PHILLIPS SCREW, M4X1545-UPRIGHT FRAME, MAIN159100074PHILLIPS SCREW, M4X8166100421ELEVATION FRAME, TREADS FY09160100395PHILLIPS SCREW, ST4.2X13167-UPRIGHT FRAME, MAIN161100076PHILLIPS SCREW, M4X12129100005BRACKET, MOTOR CONTROLLER162100395PHILLIPS SCREW, ST4.2X132610100006SUPPORT, WALK DECK163100128JAM NUT, M8411100118BELT, POLY-V 200J8 (508J8) 164402-00023NYLON LOCK NUT, M10412100433WALKING BELT, ENVY165100128JAM NUT, M8413100116WALK BOARD..KF-T6.0166100078NYLON LOCK NUT, M6414100008ROLLER, REAR KF/IM TREADS FY2009167100396WASHER, M4415100009ROLLER, REAR KF/IM TREADS FY2009169100079WASHER, M6716100425FENDER, LEFT OUTSIDE IM TREADS FY09170100397WASHER, M82117100426FENDER, LEFT INSIDE IM TREADS FY09171100081WASHER, M12218100427FENDER, RIGHT OUTSIDE IM TREADS FY09172100082WASHER,...