Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
At the same time, while stepping to the platform, grasp onto the foam handle at the front of the Treadmill. 2. Holding onto the foam handle bar, center yourself on the platform mat. 3. Standing upright in the center part of the mat and platform, start “walking” normally - the mat does not have resistance so use a relaxed pace. A ALWAYS keep your feet centered on the Treadmill mat! A ALWAYS firmly hold onto the handle bar while using this equipment! A ALWAYS use adult supervision while adjusting or setting the controls! NOTE: Periodically check the platform centered on the rollers and platform. Refer to the instructions to adjust the mat on the platform. O) CD O o Tj m > z c > (/> —1 Ol Ol ■ 0 (£> N m ■ ■ 01 cn \a va X 00 cn F4 E5 O) CD O O m > z c > ï” _L (/> H Ül Ül ■ o (/) N m ■ ■ Ül Ül \a va X 00 Ül A Troubleshooting The Walking Belt is Off Center or Slips ' If the walking belt has shifted to the left, use the Hex Driver, turn the left rear roller adjustment bolt clockwise, and the right bolt counter-clockwise 1/4 of a turn each. Run the machine for a minute. Repeat as necessary until the belt is centered. > If the walking belt has shifted to the right, use the Hex Driver, turn the left rear roller adjustment bolt counter-clockwise, and the right bolt counter-clockwise 1/4 of a turn each. Repeat as necessary until the belt is centered. NOTE: DO NOT over-tighten the belt it will cause permenant damage! ’ If the walking belt slips when walked on, use the Hex Driver, turn both rear roller adjustment bolts clockwise 1/4 of a turn. Run the machine for a minute. If the belt still slips, repeat the above step one more time. As shown in Figure 6. •If the Deluxe Stopwatch does not show “time”: 1. Check “On/Off’ switch at bottom of unit to make sure it’s “on” (red “dot” is visible). 2. Check to see if you are in the right “Mode” (see separate operating instructions for details). 3. Battery may be “low” or “dead” and will need to be replaced (see separate instructions for changing the battery). 4. Battery may be inserted wrong (see separate instructions for replacing the battery). ASSEMBLAGE Étape 1 •Attacher le tube de pied gauche au cadre principal avec 2 vis « M6 X 12MM » et 2 rondelles en plastique « 8M » fournies comme indiqué sur la Figure 1. • Répéter l'étape indiquée pour le pied de droite en utilisant 2 vis « M6 X 12MM » et 2 rondelles en plastique « 6M » fournies. Figure 1 : Côté gauche (répéter pour le côté droit) ASSEMBLAGE Étape 2 • Insérer la rampe de gauche dans le cadre principal et le tube de pied gauche. Vérifier l'alignement des trous de vis et attacher avec 4 vis « M6 • X 12MM » et 4 rondelles en plastique « M6 » fournies en utilisant le tournevis hexagonal comme indiqué sur la Figure 3. Répéter l'étape pour la rampe de droite comme indiqué. • S'assurer de vérifier l'alignement des trous de vis. REMARQUE: Ne pas serrer à fond les vis sur les deux rampe...
Эта инструкция также подходит к моделям:Тренажеры - Treadmill FF-6900 (2.67 mb)
Тренажеры - Treadmill FF-6900 (2.67 mb)