Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
2. Select one of the five modes: each, in a repeating cycle. A second mode indicator will show which mode is currently displayed. B. Speed, time, distance or calorieNTo stop the scan mode and select the speed, time, distance or calorie mode for continuous display, repeatedly press the mode button. Make sure that there is not A. ScanN When the power is turned on, the scan mode will be selected automatically. A mode indicator will appear Mode indicators by the word "SCAN." The speed, time, distance and calorie modes will all be displayed, for five seconds a mode indicator by the word OSCAN.O The modes will be selected in the following order: speed, time, distance, calorie, scan. 3. To reset the display, turn the power off and then on again by pressing the on/off button twice. 4. When you are finished exercising, press the on/off button to turn off the power. Note: If the pedals are not moved and the buttons are not pressed for four minutes, the power will turn off automatically in order to conserve the batteries. TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts of the exercise cycle regularly. To clean the exercise cycle, use a damp cloth and mild detergent. Never use abrasives or solvents; keep liquid away from the console. ELECTRONIC MONITOR If the electronic monitor does not function properly, the batteries should be replaced. Most problems are the result of drained batteries. See assembly step 4 on page 5 for battery installation instructions. If the electronic monitor still does not function properly, the sensor wire should be checked. See assembly step 4 on page 5. Slide the electronic monitor off the frame and make sure that the sensor wire is plugged fully into the wire on the electronic monitor. TIGHTENING THE PEDALS If the pedals become loose, tighten the pedal shafts into the arms of the crank. Tighten the 1/2O Locknuts onto the pedal shafts (see assembly step 7 on page 6). ADJUSTING THE CHAIN The exercise cycle features a precision chain that must be kept properly lubricated and adjusted. Apply a few drops of light multi-purpose oil to the chain every three months. If the chain is too tight, the bearings may be damaged; if the chain is too loose, the fan may be damaged. If the chain causes excessive noise or slips as you pedal, check the chain in the following way: 1. Carefully pry the Access Cover (14) off the right side shield. Reach into the access hole and press down on the chain. There should be no more than 1 inch, and no less than 1/4 inch, of vertical movement in the center of the chain. If the chain is properly adjusted, reattach the Access Cover. If the chain needs to be adjusted, see step 2. 14 8 4 2. Pry the Access Cover (14) off the left side shield. Loosen the M8 Washer Nuts (4). To tighten the chain, turn the M6 Adjustment Nuts (8) clockwise; to loosen the chain, turn the Adjust-ment Nuts counterclockwise. Make sure that the fan is straight, tighten the Fan Nuts and reattach the Access Covers. 8 CONDITIONING...
Эта инструкция также подходит к моделям:Тренажеры - 831.288264 (406.59 kb)
Тренажеры - 831.288264 (406.59 kb)
Тренажеры - 831.288264 (406.59 kb)
Тренажеры - 831.288264 (406.59 kb)