Data Mode (AE760M & AE790M Model only) Press [MODE] until you enter DATA mode The mode message "DATA" will be shown for one to two seconds before the number of free memories is to be shown. FREE 95 LAP You can press [START] to scroll through all segments. The current segment will come first. RECALL {008} 2 0 0 1 SEG {002} 2 - 1 9 A 10: 15' 30 The header consisting of the date/time stamp will be shown. The number of laps in the segment will appear in the upper left while the segment number is dis

vary with shock, temperature, or aging of crystal). Batteries Batteries should last tor 3 years. If display becomes dim, open back and replace with Duracell D357, Eveready D357, or Ray-O-Vac RW42. ACCUSPLIT, Inc. 3090 Independence Drive, Suite 148 Livermore, CA 94551 USA 800-935-1996 • 925-290-1900 • FAX 925-290-1930 support@ACCUSPLITcom

The timer cycle 12 counter will be increased by one and updated on the display. Under CS operation mode, the timer, after counting down to 0:00'00", will stay at 0:00'00"0 until you press [RESET] to reload the timer value. Under CU operation mode, the timer, after counting down to 0:00'00"0, will count up and stop at 19:59'59"9. How to set the timer Press and hold [RECALL] for 2 seconds to activate timer setting. Timer setting starts with second digits, which are shown blinking. You can press [S

The watch uses a high capacity CR2032 Lithium battery, which has an expected life of more than five years in this watch. To change the battery, you will need a set of large jeweler's screwdrivers (including Phillips head). Note: If this looks too complicated, you can always send your watch back to ACCUSPLIT for battery changing instead. See for details. 1. Turn the watch over and select the correct size Phillips screwdriver (the fastening is very tight, so the screws will strip easily if you

The three dark gray pads must be facing up (away from the case back). c. Finally, put the gasket on top of the gasket holder, and gently push both into the case back until they pop into place. 8. Turn the electronics module over so that the battery is facing the inside of the case back. Gently push the electronics module down into the gray rubber gasket, until it seats. It will be firmly in position if this is done correctly. 9. Slide the button set out of the front case (you'll see that the

$ 'Ajubjjbm aq) u; ssajppe jajuaQ jjBdaa I jssn aqj oj uonejjsiBay qojBMdois JOAi/uns I (pajjajajd) i!Bui3 jnoA ujnjaj assay yy\QN H31SI03H > GO 00 m © 2 |SJ CO o r— o m tji o > = o ■=- O -o ^ 33 00 O "O ZT C 5' —I CD Q. “1 CD § 13 CQ CT CD_ 1 tt> 00 ‘ § -i m u -< o X > CD CD W T3 CD o o' © o' 3 w ■O CD D CD 0) 3 Q. SPECIFICATIONS Batteries: Batteries should last for 18 months. If Operating Temperature: 14°F to 138°F display becomes dim, opBn back

Hold down for Rapid Review. RECHARGING To recharge the stopwatch battery, use SBLCHARGER kit (included with each watch). SBLCHARGER includes provision for charging watch from normal 120 Volt electrical outlet, from cigarette lighter in car, or from USB port on a computer. With continuous use of the backlight, the watch will last at least 10 hours before needing a recharge. If the backlight is never used, a single charge will last approximately six months (up to one year if stopwatch is used

-Press R to select Minutes, Hour, Month, Date, Day, Seconds. -Press L to change any of the above. (Seconds only resets to 00). (Hold L to change digits rapidly). -Press C to return to TIME display. TO SET MEMO TIME -Hold C for 3 seconds to enter MEMO TIME SET MODE. -Press R to select Minutes and Hours. -Press Lto change Minutes and Hours. -Press C to return to TIME display. TO SET 12/24 HOUR FORMAT -Hold R and Press C to interchange 12P or 24 format. BATTERY CHANGING See Specification

The Dual Split time will be frozen for five seconds. After five seconds, the Display returns to the running CUM and LAP times. Press STOP button to stop the stopwatch. The last Dual Split time will also be stored (provided that the last spilt time Is not the first split time). The stopwatch can store up to 100 Dual Split times. The fastest lap, the slowest lap and the averages of all laps will also be recorded. When there are five free memories left, the Icon “FULL” will blink to remind yo

5. S4 – After all the adjustments are completed, press “A” repeatedly until watch exits set mode and returns to the TIME/CALENDAR display. Notes: 1. Hour digits are displayed in the 24-hour indication. 2. Year digits can be set from 1988 to 2027. The calendar adjusts automatically for odd and even months including February of leap years. seconds minutes hour year month date Note: The watch exits set mode automatically after setting date. 8-9 A A B • “Split time” refers to an elapsed time requir