Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
¦ Auto Recovery can be disabled by sliding the Recovery switch on the circuit board. ¦ Auto Recovery will not operate if Permanent hold or Temporary hold is in operation. ¦ Auto Recovery can be canceled manually if HOLD / RETURN is pressed during the recovery process. ¦ Auto Recovery will be canceled and change to Temporary Manual Override mode if the setpoint is adjusted during the recovery process. Error Mode If the thermostat is unable to control your system due to an unexpected battery problem, the thermostat will enter Error Mode. In this condition, the thermostat flashes “Err” on the LCD display, and shuts off your system. To correct this problem, replace the batteries with 2 new AA alkaline batteries, even if you have recently replaced them. Next, use a paper clip to press the RESET button next to the keypad. You will need to reprogram your thermostat and confirm normal operation. HEAT TEMP 2 If Error Mode returns, please call Hunter Technical support at 1-866-268-1936 for further information. Auto Cut Off Your thermostat will automatically cut-off in Heat mode if the room temperature rises above 35°C (95°F). It will cut-off in Cool mode if the room temperature drops below 4°C (40°F). Note that if your system has malfunctioned and no longer responds to thermostat controls, the Auto Cut-Off will have no effect. TROUBLESHOOTING Problem Solution No Display 1. Check battery connections and batteries. 2. Press RESET button with a small pin and hold in for two seconds. Entire Display Dims 1. Replace Batteries Program Does Not Change at your Desired Setting 1. Check that the time is set properly to “AM” or “PM”. 2. Check that the thermostat is not in Permanent HOLD mode. 3. Check for the correct day setting. Auto Fan Does Not 1. Move HG/HE selector to correct position. Turn On Properly Heating or Cooling Does Not Go On or Off 1. Check that the function switch is in the correct position (“HEAT” or “COOL”). 2. There may be as much as 4-minute delay before the system turns On – wait and check. (Compressor protection delay.) 3. Check your circuit breakers and switches to ensure there is power to the system. 4. Replace batteries. 5. Make sure your furnace blower door is closed properly. 6. If your non-heat pump system only uses 4-wires, be sure the jumper wire is installed between the RC and RH terminals. 7. Check the position of the System Selector switch: Standard or Heat Pump. Erratic Display 1. Press the reset button once with a small pin and hold for two seconds. Then reprogram. If unit continues to operate in the Off position 1. Replace unit. Thermostat permanently reads “HI”, “LO”, or “ERR” 1. Replace unit. If you experience any other problems, call 1-866-268-1936 from 8 AM to 5 PM Central Time for technical assistance. Hunter Fan Company Canada 45 BRAMALEA ROAD, SUITE 207 © 2003 Hunter Fan Company ® BRAMPTON, ONTARIO L6T 2W4 41658-01 07/01/03 ...
Эта инструкция также подходит к моделям:Термостаты - 47250A (309.69 kb)
Термостаты - 47250A (309.69 kb)