Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Especially pay attention to children not to do so. - Fasten all the screws firmly when assembling the speaker stand, and check its tightness afterwards regularly. - Do not install any overweight equipment (over 10 kg) on the speaker stand. ■ Checking the supplied parts Check to be sure you have the following supplied parts. The quantity of piece supplied is for one pair of speaker stands. Top plate---------------------2 Bottom plate---------------2 o o Screws @-------------------6 Screws ®-------------------6 (Black: M6 x 30 mm) (Black: M6 x 16 mm) If any item is missing, contact your dealer immediately. ■ Precautions • For safety use - Do not climb or hang on to the speaker stand. - Attach the speaker firmly to the speaker stand. • For installation - While installing the speaker on the stand, do not drop it from the stand. Pay attention not to damage the speaker cabinet. - To obtain the best bass sound quality, install the speaker stand on the flat floor. • For daily use - Wipe with a dry, soft cloth if the speaker stand should become dirty. If very dirty, wipe with a cloth applied a small amount of water or neutral detergent, then wipe with a dry cloth. - Do not use chemicals such as benzine and thinner for cleaning the speaker stand; otherwise, the speaker stand may deteriorate or its paint may come off. Leg (D------ ----------------4 m (thin) 2 | Assembly_ Before assembling— • Prepare a Phillips screwdriver. • Place a large, thick cloth on the floor where you assemble the speaker stand to protect the floor and the speaker stand. ■ Assembling the speaker stand • Tighten the screws firmly so that no space is left between the legs and plates. 1 Fix the top plate. • Align the projection of the legs to the holes of the top plate correctly, then attach them with three of the supplied screws ® (M6 x 16 mm). 2 Fix the bottom plate and leg holders. • Align the projection of the legs to the holes of the bottom plate correctly, then attach them with three of the supplied screws ® (M6 x 30 mm). 3 Finally tighten screws ® and @ fully. • Tighten them firmly and fully so that no space is left between the legs and plates. | Installing Speaker_ ■ Attach the speaker on the stand 1 Locate the speaker properly by aligning both screw holes of the speaker and the speaker stand. • Do not install the speaker stand on an uneven surface or in a place subject to vibration. • Do not install any overweight equipment (over 10 kg) on the speaker stand. 2 Fix the speaker with the supplied screws © (M5 x 28 mm). • Do not overtighten the screws, but firmly enough to prevent the speakers from being shaky. | Specifications Mass: 5.3 kg each Maximum load: 10 kg Dimensions: See the diagram. Unit: mm Design and specifications subject to change without notice. 3 English ф EN, CS, CT © 2004 Victor Company of Japan, Limited CO CO ■0 m A * m 33 S JVC...
Эта инструкция также подходит к моделям:Телевизоры - LVT1248-002A (410.92 kb)