Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Symbol Input Signals 1 • Audio / video input signal through the Scart connector G 1 • RGB input signal through the Scart connector G. This symbol appears only if an RGB source has been connected. 2 • Audio / video input signal through the Scart connector F. 2 • RGB input signal through the Scart connector F. This symbol appears only if an S S RGB source has been connected. 3 • Audio/video input signal through the Scart connector E. 3 • S Video Input signal through the Scart connector E. This symbol appears only if an S Video source has been connected. 4 • Video input signal through the phono socket B and Audio input signal through C. 4 • S Video Input signal through the front S Video input jack A and Audio signal through C. This symbol appears only if an S Video source has been connected. 5 • RGB input signal through the PC connector H and I. 4 Press the button on the remote control to return to the normal TV picture. GB For Mono Equipment Connect the phono plug to the L/G/S/I socket on the front of the TV and select 4 or S 4 input signal using the instructions above. Next, refer to the “Sound Adjustment” section of this manual and set “Dual Sound” option to “A” on the sound menu screen (see page 14). 25 Additional Information Remote Control Configuration for VCR or DVD In it’s default condition this remote control will operate the basic functions of this Sony TV, Sony DVDs and most Sony VCRs. To control VCRs and DVDs of other manufacturers (and some Sony VCR models), the remote control needs to be configured. To do this: fig. 3 • Before you start, look up the 3 digit code for your brand of DVD or VCR from the list below. On those brands that have more than one code, enter the first code number. • A small label is added inside the battery door to allow you to record your brand codes. 1 Press the Media Selector button until the required green light (VCR or fig. 1 DVD) is lit (see fig. 1). 2 Before the green light goes out, press and hold the yellow button for approximately 6 seconds until the green light (VCR or DVD) starts flashing (see fig. 2.). 3 While the VCR and DVD lights are flashing, enter all three digits of the code for your brand of VCR or DVD (see the list below) using the number fig. 2 buttons on the remote control (see fig. 3). If your selected code is entered correctly, the three green lights will be lit momentarily. Otherwise repeat all the above steps. 4 Turn on your VCR or DVD and check that the main functions work. • If your device is not working or some of the functions do not 6 sec. work please check that you entered the correct code set or try the next code listed against the brand. • Not all brands are covered and not all models of every brand may be covered. 5 Always remember to press Media Selector button until the green light iluminates according to the equipment you want to operate with this remote control: VCR, TV...
Эта инструкция также подходит к моделям:Телевизоры - KF-50SX300U (6.57 mb)