Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
See “Limited United States Warranty” on page 107. If you use the lamp beyond its service life: • you may notice a reduction in the colors and/or brightness of the picture; and • the strength of the quartz glass in the lamp will be reduced and the lamp may rupture (often making a loud noise when this happens). If the lamp ruptures, the TV will not operate until the lamp unit is replaced. CAUTION: Always handle the lamp unit with care. The lamp unit in this TV was designed for safe replacement by consumers; however, if the lamp unit is subjected to intentional abuse (such as excessive mechanical abuse or handling by children or pets), the unit may break, exposing sharp edges or pinch points. When to replace the lamp unit You should replace the lamp unit: • if the picture darkens and/or colors fade; • if the screen (lamp) does not light (LED indication #3, page 99); or • if you hear a loud noise and the picture goes black, which may indicate a lamp rupture (LED indication #3, page 99). To obtain a replacement lamp unit: In warranty WebContact Call toll-free 1-800-631-3811. Out of warranty your consumer electronics dealer for availability. Use the replacement lamp unit model listed below only. Using any other lamp may cause damage to the TV and/or lamp. CAUTION: Always replace with same type lamp unit: Model No. D95-LMP (Stock no. 23311153) Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 103 Chapter 11: Appendix Lamp unit replacement and care (continued) WARNING: RISK OF ELECTRIC SHOCK! TO REDUCE THE RISK OF ELECTRIC SHOCK, NEVER REMOVE TV COVERS, EXCEPT AS SPECIFIED HEREIN. REFER ALL SERVICING NOT SPECIFIED IN THIS MANUAL TO QUALIFIED SERVICE PERSONNEL. Failure to follow this WARNING may result in death or serious injury. 4. Using a manual Phillips screwdriver, loosen the two screws on How to replace the lamp unit the lamp unit. Required tools: • Manual Phillips screwdriver • Soft, lint-free gloves. Optional tool: 5/32” or 4mm Allen wrench. 1. Turn off the TV and unplug the power cord. WARNING: Eye damage may result from directly viewing the light produced by this lamp. Always turn off the TV and unplug the power cord before opening the lamp unit door. 2. STOP! Allow the lamp to cool for at least one (1) hour before replacing it. CAUTION: HOT SURFACE! The temperature of the lamp immediately after use exceeds 392°F (200°C). Touching the lamp before it has cooled will result in severe burns. ALLOW THE LAMP TO COOL FOR AT LEAST ONE (1) HOUR BEFORE REPLACING IT. 3. On the lamp unit door on the side of the TV, loosen the thumb screw by hand or by using a 5/32” or 4mm Allen wrench, and then remove the lamp unit door. TV back WARNING: RISK OF ELECTRIC SHOCK! The lamp unit door is provided with an interlock to reduce the risk ...
Эта инструкция также подходит к моделям:Телевизоры - 46HM15 (4.61 mb)
Телевизоры - 46HM15 (4.61 mb)
Телевизоры - 62HM15A (4.61 mb)