Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
• If the TV still does not act as expected, use the Restore Factory Defaults procedure (- page 22). Channel tuning problems • Make sure the remote control is set to the correct device mode (- page 8). • The channel may have been erased from the channel memory by the Channel Add/Delete feature. Add the channel to the channel memory (- page 17). • The channel may be blocked by the Channels Block feature. Unblock the channel (- page 37). • If you are unable to tune digital channels, check the antenna configuration (- page 16). If you are still unable to tune digital channels, clear all channels from the channel list (- page 18) and reprogram channels into the channel memory (- page 17). If you are still unable to tune digital channels, use the Restore Factory Defaults procedure (- page 22). Also see “TV stops responding to controls” and “Other problems” (-page 44). Closed caption problems • If the program or video you selected is not closed- captioned, no captions will display on-screen (- page 31). • If text is not available, a black rectangle may appear on- screen. If this happens, turn off the closed caption feature (-page 31). • A closed caption signal may not display correctly in the following situations: a) when a videotape has been dubbed; b) when the signal reception is weak; or c) when the signal reception is nonstandard (- page 31). Rating blocking (V-Chip) problems • If you forget your PIN code: While the PIN code entering screen is displayed, press Efour times within 5 seconds. The PIN code you previously stored will be cleared (- page 35). • The V-Chip feature is available for the U.S. V-Chip system only (-page 36). 45 HM66 (E/F) Web 213:276 HM66_EN.book Page 46 Thursday, February 23, 2006 2:49 PM Chapter 7: Troubleshooting LED indications The yellow blue and red/green LED lights on the TV (at the bottom center of the TV) indicate the TV’s status, as described below: Note: If the TV loses A/C power (e.g., a power outage occurs or the power cord is unplugged), when power is restored, the yellow LED will blink while the TV is booting until the remote control is usable. This is normal and is not a sign of malfunction. “Voice announce” feature When certain non-standard conditions occur, the LEDs on the TV will blink and the TV will play a recorded “voice announcement” describing the condition (see the table below for the specific conditions that include a voice announcement). To repeat the voice announcement and hear additional information, press the MENU button on the TV while the LEDs are blinking. Blue LED Red/Green LED Yellow LED TV front LED Indication Condition Solution Voice announce 1) Blue is ON (solid). The TV is operating properly. – – 2) Yellow blinks. In LPS mode (standby with Quick Restart ON). See “Setting the Quick Restart™ feature” (- page 20). – 3) Blue is ON (solid). Yellow blinks. The lamp is not working properly. The TV will automatically try to restart itself e...
Эта инструкция также подходит к моделям:Телевизоры - 50HM66 (2.17 mb)
Телевизоры - 50HM66 (2.17 mb)
Телевизоры - 56HM66 (2.17 mb)