Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
2) Place the TV on a sturdy, level surface that can support the weight of the TV. 3) Be sure to secure the TV to a wall, pillar, surface, or other immovable structure. ( item 25, page 4). To Di spl ay your LCD TV usi ng a Wal l Br ac ket : If you decide to wall mount your LCD TV, always use a UL listed wall bracket appropriate for the size and weight of the LCD TV ( page 2): 1) CAUTION: Two people are required for installation. 2) Unplug and remove any cables and/or other component connectors from the rear of the TV. 3) Remove the screws of the VESA Mounting Pattern show in the next page. CAUTION: Do not use the screws removed from the back cover to attach the wall mount bracket to the TV. 4) Always use the screws supplied or recommended by the wall mount manufacturer. 5) Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket. 6) After attaching the appropriate bracket(s) to the wall and the back of the TV, remove the pedestal stand from the TV as described on the following page. 7) VESA Mounting Pattern TV Size Hole Pattern (HxV) Screw Size 19” 100x100 mm M4 24” 100x100 mm M4 32” 200x200 mm M6 (unit in mm) Removing the Pedestal Stand 1) Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface. Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel. 2) Remove the four screws shown in the below diagram. This will allow removal of the pedestal stand. 3) Once you have removed the four screws that hold the pedestal stand in place, remove the pedestal stand from the TV. 19” TV VESA Mounting Pattern 24” TV 32” TV Sturdy strap (as short as possible) Four screws Hook Sturdy strap(as short as possible) VESA Mounting Pattern Four screws Hook Sturdy strap (as short as possible) VESA Mounting Pattern Hook Four screws FCC Declaration of Conformity Compliance Statement (Part 15): The Toshi ba 19SL410U, 24SL410U, and 32SL410U Tel evi si ons comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interferencereceived, including interference that may cause undesired operation. The party responsible for compliance to these rules is: Toshiba America Information Systems, Inc. 9740 Irvine Blvd.; Irvine, CA 92618 Ph: 1-800-631-3811 Note: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and...
Эта инструкция также подходит к моделям:Телевизоры - 19SL410U (8.94 mb)
Телевизоры - 24SL410U (8.94 mb)
Телевизоры - 24SL410UM (8.94 mb)
Телевизоры - 32SL410U (8.94 mb)