Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
• If you have not created a password, the TV is initially set up with the password "0000". • If you cannot remember your password, press "7777". 3. Press .. or .. to highlight Panel Lock. Press • or .. to select On (Lock) or Off (Unlock). Block Setting Change Password > V-Chip Blocking Setting Panel Lock Off Enter Password: - - - - MENU/ENTER EXIT Displaying on-screen information Press DISPLAY to display the following information on- screen: • Channel number or Video mode selected • Stereo or SAP audio status Understanding the last mode memory feature If the power is cut off while you are viewing the TV, the Last Mode Memory feature turns on the TV automatically when the power is resupplied. If the power is going to be off for a long time and you are going to be away from your TV, unplug the power cord to prevent the TV from turning on in your absence. Note: With the panel locked, you can prevent your TV settings from being changed accidentally (by children, for example). When the Panel Lock is on, no control buttons on the TV side panel will operate except POWER. DISPLAY MENU/ ENTER Number 36 E Appendix Specifications • This model complies with the specifications listed below. • Designs and specifications are subject to change without notice. • This model may not be compatible with features and/or specifications that may be added in the future. WARNING: RISK OF ELECTRIC SHOCK! Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to a Toshiba Authorized Service Center. Television System NTSC standard Channel Coverage VHF: 2 through 13 UHF: 14 through 69 Cable TV: Mid band (A-8 through A-1, A through I) Super band (J through W) Hyper band (AA through ZZ, AAA, BBB) Ultra band (65 through 94, 100 through 125) Power Source 120 V AC, 60 Hz Power Consumption 70 W < 1 W in standby mode Audio Power 2 W + 2 W Video/Audio Terminals S-VIDEO INPUT Y: 1 V(p-p), 75 ohms, negative sync. C: 0.286 V(p-p) (burst signal), 75 ohms VIDEO/AUDIO INPUT VIDEO: 1 V(p-p), 75 ohms, negative sync. AUDIO: 400 mV(rms) (30% modulation equivalent, 22k ohms or greater) ColorStream® (Component video) INPUT Y: 1V(p-p), 75 ohms PR: 0.7 V(p-p), 75 ohms PB: 0.7 V(p-p), 75 ohms AUDIO: 500 mV(rms), 47k ohms or greater Suggested resolutions: 1080i, 480p, 480i, 720p AUDIO OUTPUT 500 mV(rms) (30% modulation equivalent, 2.2k ohms or less) HEADPHONE jack 3.5 mm stereo mini jack PC INPUT 15-pin D-sub Analog RGB PC AUDIO INPUT 3.5 mm stereo mini jack HDMITM INPUT: HDMI compliant (type A connector) HDCP compliant E-EDID* compliant Suggested scan rates: 1080i, 480p, 480i, 720p HDMI Audio: 2-channel PCM; 32/44.1/48 kHz sampling frequency; 16/20/24 bits per sample Note: This TV does not provide HDMI OUTPUT. Dimensions (Including TV stand) Width: 21-1/8 inches (537 mm) Height: 15-5/16 inches (389 mm) Depth: 9-5/16 inches (236 mm) Mass (weight) 18.0 lbs (8.2 kg) Operating conditions Temperature: 32°F–95°F (0°C–35°C) Humidity: 20 – 80% (no moisture condensation) *E-EDID = Enhanced-Extended Display Identification 37 F S IntroductionConnecting your TV Using the remote control Setting up your TV Using the TV's features AppendixIndex Troubleshooting Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions. Symptom Solution TV will not turn on • Make sure the power cord is plugged in, then press POWER. • The remote control battery may be dead. Replace the battery. No picture, no sound • Check the antenna/cable connections. No sound, picture OK • The sound may be muted. Press VOL + –. • The station may have broadcast difficulties. Try another channel. • Make sure the MTS feature is set properly. Poor picture, sound OK • Check the antenna connections. • The station may have broadcast difficulties. Try another channel. • Adjust the Picture menu. Poor reception of broadcast channels • The station may have broadcast difficulties. Try another channel. • Check the antenna connections. Black box appears on the screen • The Closed Caption feature may be set to one of the Text modes (Text1, Text2, Text3, or Text4). Turn closed captioning Off. Unable to select a certain channel • The channel may be erased with the Manual programming feature. Multiple images • The station may have broadcast difficulties. Try another channel. • Antenna reception may be poor. Use a highly directional outdoor antenna. Poor color or no color • The station may have broadcast difficulties. Try another channel. • Adjust the Tint and/or Color in the Picture menu. No stereo or SAP sound from a known MTS broadcast • Make sure the MTS feature is set properly. The side panel buttons do not operate • Check the Panel Lock feature. The remote control does not operate • Remove all obstructions between the remote control and the remote control sensor in the TV. • The remote control battery may be dead. Replace the battery. Appendix 38 E F Limited Unit...
Эта инструкция также подходит к моделям:Телевизоры - 20HLK86 (1.53 mb)