Оценок - 2, средний балл: 4.5
(
)
)
|
Фото и характеристики Sony KDL-20B4030 |
К этому устройству также есть другие инструкции:
Фрагмент инструкции
~ • Observe the correct polarity when inserting batteries. • Do not use different types of batteries together or mix old and new batteries. • Dispose of batteries in an environmentally friendly way. Certain regions may regulate disposal of batteries. Please consult your local authority. • Handle the remote with care. Do not drop or step on it, or spill liquid of any kind onto it. • Do not place the remote in a location near a heat source, a place subject to direct sunlight, or a damp room. Connecting an aerial only Connecting an aerial/ VCR/ DVD recorder Coaxial cable Scart lead VCR Coaxial cable Coaxial cable 4 GB 3: Preventing the TV from toppling over For additional stability, the hole on the back of the TV can be used to secure the TV to a wall. 1 Unplug the TV. 2 Run suitable cable (not supplied) through the hole on the back of the TV. Cable (not supplied) 3 Anchor the cable to a stable surface such as a wall or pillar. Tighten the cable Wall anchor bracket (not supplied) 4: Selecting the language, country/region and location 3,4,5 1 Connect the TV to your mains socket (220-240V AC, 50Hz). 2 Press 1 on the TV. When you switch on the TV for the first time, the Language menu appears on the screen. 3 Press F/f to select the language displayed on the menu screens, then press . Auto Start Up Language Country Location Select: Confirm: Start-up Continued 5 GB 4 Press F/f to select the country/region in which you will operate the TV, then press . Auto Start Up Language Country Location Select: Confirm: Back: If the country/region in which you want to use the TV does not appear in the list, select “-” instead of a country/region. 5 Press F/f to select the location type in which you will operate the TV, then press . Auto Start Up Language Country Location Select: Confirm: Back: Home Shop This option selects the initial picture mode appropiate for the typical lighting condition in these enviroments. 5: Auto-tuning the TV 1 Before you start auto-tuning the TV, insert a pre-recorded tape into the VCR connected to the TV (page 4) and start play back. The video channel will be located and stored on the TV during auto-tuning. If no VCR is connected to the TV, skip this step. 2 Press . press any buttons on the TV or remote while proceeding. If a message appears for you to confirm the aerial connection No digital or analogue channels were found. Check all the aerial connections and press to start auto-tuning again. 3 When the Programme Sorting menu appears on the screen, follow the steps of “Programme Sorting” (page 26). If you do not change the order in which the analogue channels are stored on the TV, go to step 4. 4 Press MENU to exit. The TV has now tuned in all the available channels. ~ When a digital broadcast channel cannot be received, or when selecting a region in which there are no digital broadcasts in step 4 (page 6), the time must be set after performing step 4. Back: Start: Cancel: MENU Do you want to start automatic tuning? The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not 6 GB – Do not install the TV set as shown below. Air circulation Safety information is blocked. Installation/Set-up Install and use the TV set in accordance with the instructions below in order to avoid any risk of fire, electrical shock or damage and/or injuries. Installation • The TV set should be installed near an easily accessible mains socket. • Place the TV set on a stable, level surface. • This TV set cannot be fixed to a wall. Transporting • Before transporting the TV set, disconnect all cables. • When transporting the TV set by hand, hold it as shown on the right. Do not put stress on the LCD panel and the frame around the screen. • When transporting the TV set, do not subject it to jolts or excessive vibration. • When transporting the TV set for repairs or when moving, pack it using the original carton and packing material. Ventilation • Never cover the ventilation holes or insert anything in the cabinet. • Leave space around the TV set as shown below. Installed with stand 30 cm 10 cm10 cm 6 cm Leave at least this space around the set. • To ensure proper ventilation and prevent the collection of dirt or dust: – Do not lay the TV set flat, install upside down, backwards, or sideways. – Do not place the TV set on a shelf, rug, bed or in a closet. – Do not cover the TV set with a cloth, such as curtains, or items such as newspapers, etc. Wall Mains lead Handle the mains lead and socket as follows in order to avoid any risk of fire, electrical shock or damage and/or injuries: – Use only Sony mains leads, not those of other brands. – Insert the plug fully into the mains socket. – Operate the TV set on a 220-240 V AC supply only. – When wiring cables, be sure to unplug the mains lead for your safety and take care not to catch your feet on the cables. – Disconnect the mains lead from the mains socket before working on or moving the TV set. – Kee...
Эта инструкция также подходит к моделям:Телевизоры - KDL-20B4050 (5.76 mb)
Телевизоры - KDL-23B4030 (5.76 mb)
Телевизоры - KDL-23B4050 (5.76 mb)