Оценок - 3, средний балл: 4.3
(
)
)
|
Фото и характеристики Sony KDL-40EX1 |
Фрагмент инструкции
To Sony Dealers and Contractors: Provide full attention to safety during the installation, periodic maintenance and examination of this product. Your monitor can be installed using the Wall-Mount Bracket SU-WL500/SU-WL700 (sold separately). For SU-WL500, install as illustrated below. For SU-WL700, see the manual supplied with SU-WL700. • Refer to the Instructions supplied with the Wall-Mount Bracket to properly carry out the installation. • Refer to “Detaching the Table-Top Stand from the Monitor” (page 11). • Refer to “Monitor installation dimensions table” (page 45). • Refer to “Screw and Hook locations diagram/table” (page 45). Screw (+PSW6 . 16) Mounting Hook Square hole Screw 12 Sufficient expertise is required for installing this product, especially to determine the strength of the wall for withstanding the monitor’s weight. Be sure to entrust the attachment of this product to the wall to Sony dealers or licenced contractors and pay adequate attention to safety during the installation. Sony is not liable for any damage or injury caused by mishandling or improper installation. 44 GB Monitor installation dimensions table 320 Screen centre point Unit: mm Model Name Display dimensions Screen centre dimension Length for each mounting angle Angle (0°) Angle (20°) A B C D E F G H KDL-52EX1 1,312 806 80 486 114 351 765 508 KDL-46EX1 1,156 709 107 464 110 321 674 486 KDL-40EX1 1,024 635 144 464 110 296 604 486 Figures in the above table may differ slightly depending on the installation. WARNING The wall that the monitor will be installed on should be capable of supporting a weight of at least four times that of the monitor. Refer to “Specifications” on page 46 for its weight. Screw and Hook locations diagram/table Model Name Screw location Hook location KDL-52EX1/46EX1/40EX1 e, j b * Hook position “a” and “c” cannot be used for the models in the table above. Screw location Hook location a* b c* Additional Information 45 GB Specifications Media receiver Model name MBT-W1 System TV system Analogue: Depending on your country selection: B/G/H, D/K, L, I Digital: DVB-T/DVB-C Colour/video system Analogue: PAL, SECAM NTSC 3.58, 4.43 (only Video In) Digital: MPEG-2 MP@ML/HL, H.264/MPEG-4 AVC HP@L4.0, MP@L3.0 Channel coverage Analogue: VHF: E2–E12/UHF: E21–E69/CATV: S1–S20/HYPER: S21–S41 D/K: R1–R12, R21–R69/L: F2–F10, B–Q, F21–F69/I: UHF B21–B69 Digital: VHF/UHF Input/Output jacks Aerial 75 ohm external terminal for VHF/UHF / AV1 21-pin Scart connector (CENELEC standard) including audio/video input, RGB input and unit audio/video output. AV2 Video input (phono jack) AV2 Audio input (phono jacks) DIGITAL AUDIO OUT (OPTICAL)(digital optical jack) COMPONENT IN Supported formats: 1080p, 1080i, 720p, 576p, 576i, 480p, 480i Y: 1 Vp-p, 75 ohms, 0.3V negative sync PB/CB: 0.7 Vp-p, 75 ohms PR/CR: 0.7 Vp-p, 75 ohms COMPONENT IN Audio input (phono jacks) 500 mVrms HDMI IN 1, 2, 3 Video: 1080p, 1080i, 720p, 576p, 576i, 480p, 480i Audio: Two channel linear PCM 32, 44.1 and 48 kHz, 16, 20 and 24 bits PC Input (see page 48) PC IN PC Input (D-sub 15-pin) G: 0.7 Vp-p, 75 ohms, non Sync on Green B: 0.7 Vp-p, 75 ohms, non Sync on Green R: 0.7 Vp-p, 75 ohms, non Sync on Green HD: 1-5 Vp-p VD: 1-5 Vp-p PC audio input (minijack) IR BLASTER 3.5 mm minijack CAM (Conditional Access Module) slot i Headphones jack USB port Power and others Power requirements Mains adaptor: 100-240 V AC, 50/60 Hz Media receiver: DC18V Power consumption 20 W Standby power consumption* 3.5 W or less (19 W when Quick Start is ON) Dimensions (Approx.) (w . h . d) for vertical placement with stand 13.1 . 30.2 . 28.6 cm for horizontal placement 28.0 . 7.2 . 28.6 cm Mass (Approx.) for vertical placement with stand 2.5 kg for horizontal placement 2.4 kg 46 GB Monitor Model name LDM-E521 LDM-E461 LDM-E401 System Panel system LCD (Liquid Crystal Display) Panel Sound output 8 W + 8 W Input/Output jacks MONITOR HDMI IN Video: 1080/24p, 1080p, 1080i, 720p, 576p, 576i, 480p, 480i Audio: Two channel linear PCM 32, 44.1 and 48 kHz, 16, 20 and 24 bits PC Input (see page 48) Power and others Power requirements 220–240 V AC, 50 Hz Screen size (measured diagonally) 52 inches (Approx. 132.2 cm) 46 inches (Approx. 116.8 cm) 40 inches (Approx. 101.6 cm) Display resolution 1,920 dots (horizontal) . 1,080 lines (vertical) Power consumption in “Home”/ “Standard” mode 295 W 220 W 180 W in “Shop”/“Vivid” mode 324 W 247 W 221 W Standby power consumption* 0.5 W or less (19 W when Quick Start is ON) Dimensions (Approx.) (w . h . d) with Table-Top Stand 131.2 . 83.9 . 34.4 cm 115.6 . 74.2 . 25.5 cm 102.4 . 66.8 . 25.5 cm without Table-Top Stand 131.2 . 80.6 . 5.7 cm 115.6 . 70.9 . 5.7 cm 102.4 . 63.5 . 5.7 cm Mass (Approx.) with Table-Top Stand 43.0 kg 26.0 kg 24.0 kg without Table-Top Stand 33.0 kg 19.0 kg 17.0 kg Supplied accessories See “1: Checking the unit and accessories” on page 4. Optional accessories SU-WL500/SU-WL700 Wall-Mount Bracket * Specified standby power is reached after the u...
Эта инструкция также подходит к моделям:Телевизоры - KDL-46EX1 (4.01 mb)
Телевизоры - KDL-52EX1 (4.01 mb)