Оценок - 2, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
139.7 cm measured diagonally) Power Consumption: 210 W Standby Power Consumption: 0.5 W Dimensions (w x h x d): Approx. 1,292 x 913 x 480 mm Mass: Approx. 39 kg TV System Analogue: Depending on your country/region selection: B/G/H, D/K, L, I Digital: DVB-T Colour/Video System Analogue: PAL, SECAM NTSC 3.58, 4.43 (only Video In) Digital: MPEG-2 MP@ML Aerial 75 ohm external terminal for VHF/UHF Channel Coverage Analogue: VHF: E2-E12 UHF: E21-E69 CATV: S1-S20 HYPER: S21-S41 D/K: R1-R12, R21-R69 L: F2-F10, B-Q, F21-F69 I: UHF B21-B69 VHF/UHF Terminals ©♦•KB1 21-pin scart connector (CENELEC standard) including audio/video input, RGB input, and TV audio/video output. (SmartLink) 21-pin scart connector (CENELEC standard) including audio/video input, RGB input, selectable audio/video output, and SmartLink interface. 21-pin scart connector (CENELEC standard) including audio/video input, RGB input, S video input, and audio/ video output which currently appears on the screen. -34 Supported formats: 1080i, 720p, 576p, 576i, 480p, 480i Y: 1 Vp-p, 75 ohms, 0.3 V negative sync Pb/Cb: 0.7 Vp-p, 75 ohms Pr/Cr: 0.7 Vp-p, 75 ohms —Q4 Audio input (phono jacks) 500 mVrms Impedance: 47 kilohms HDMI IN 5, 6 Video: 1080p, 1080i, 720p, 576p, 576i, 480p, 480i Audio: Two channel linear PCM 32, 44.1 and 48 kHz, 16, 20 and 24 bits Analogue audio (phono jacks): 500 mVrms, Impedance 47 kilohms (HDMI IN 6 only) -37 Supported formats: 1080i, 720p, 576p, 576i, 480p, 480i Y: 1 Vp-p, 75 ohms, 0.3V negative sync Pb/Cb: 0.7 Vp-p, 75 ohms Pr/Cr: 0.7 Vp-p, 75 ohms -©7 Video input (phono jack) -©7 Audio input (phono jacks) DIGITAL OUT (OPTICAL OUT jack) Q— Audio output (phono jacks) PC -<3 PC Input (D-sub 15-pin) (see page 51) G: 0.7 Vp-p, 75 ohms, non Sync on Green B: 0.7 Vp-p, 75 ohms R: 0.7 Vp-p, 75 ohms HD: 1-5 Vp-p VD: 1-5 Vp-p -© PC audio input (minijack) 0 Headphones jack n\ CAM (Conditional Access Module) slot Sound Output 12 W + 12 W Supplied Accessories Refer to “1: Checking the accessories” on page 4. Optional Accessories TV stand SU-RS11X Design and specifications are subject to change without notice. 50 GB PC Input Signal Reference Chart Signals Horizontal (Pixel) Vertical (Line) Horizontal frequency (kHz) Vertical frequency (Hz) Standard VGA 640 480 31.5 60 VGA 640 480 37.5 75 VESA 720 400 31.5 79 VGA-T SVGA 800 600 37.9 60 VESA Guidelines 800 600 46.9 75 VESA XGA 1024 768 48.4 60 VESA Guidelines 1024 768 56.5 70 VESA 1024 768 60 75 VESA 1280 720 44.7 60 VESA CVT WXGA 1280 768 47.4 60 VESA 1280 768 47.8 60 VESA 1280 768 60.3 75 VESA 1360 768 47.7 60 VESA SXGA 1280 1024 64 60 VESA 1280 1024 80 75 VESA HDTV 1920 1080 67.5 60 EIA • This TV’s PC input does not support Sync on Green or Composite Sync. • The PC input signal displays on-screen in a smaller size than the actual TV screen size and does not support interlaced signals. • For the best picture quality, it is recommended to use the signals (boldfaced) in the above chart with a 60 Hz vertical frequency from a personal computer. In plug and play, signals with a 60 Hz vertical frequency will be selected automatically. 51 GB Additional Information Troubleshooting Check whether the 1 (on/standby) indicator is flashing in red. When it is flashing The self-diagnosis function is activated. (When the indicator flashes in two- or three-blink intervals, see page 54.) 1 Count how many 1 (on/standby) indicator flashes between each two second break. For example, the indicator flashes three times, then there is a two second break, followed by another three flashes, etc. 2 Press 1 on the TV (front) to switch it off, disconnect the mains lead, and inform your dealer or Sony service centre of how the indicator flashes (number of flashes). When it is not flashing 1 Check the items in the tables below. 2 If the problem still persists, have your TV serviced by qualified service personnel. Picture Problem Cause/Remedy No picture (screen is dark) and no sound • Check the aerial connection. • Connect the TV to the mains, and press 1 on the TV (front). • If the 1 (on/standby) indicator lights up in red, press TV 1/1. No picture or no menu information from equipment connected to the scart connector • Check that the optional equipment is on and press -0/© repeatedly until the correct input symbol is displayed on the screen. • Check the connection between the optional equipment and the TV. Double images or ghosting • Check aerial/cable connections. • Check the aerial location and direction. Only snow and noise appear on the screen • Check if the aerial is broken or bent. • Check if the aerial has reached the end of its serviceable life (three to five years in normal use, one to two years at the seaside). Distorted picture (dotted lines or stripes) • Keep the TV away from electrical noise sources such as cars, motorcycles, hair-dryers or optical equipment. • When installing optional equipment, leave ...