|
Фрагмент инструкции
If cleaning beyond this is needed, please use the following guidelines: First, turn off the TV and unplug the power cord from the power outlet. Top and Sides of the TV: • Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth. • For oily dirt, add a few drops of mild liquid detergent, such as dishwashing detergent to the water used to moisten the cloth. Rinse with a second cloth moistened only with water. Dry with a third dry, soft, non-abrasive cloth. Screen: • Follow the instructions for the top and sides, but wipe gently in an up and down motion, following the grooves in the screen. • Clean the entire screen evenly, not just sections of the screen. • Do not allow liquid to drip down the grooves of the screen, as some liquid may enter the TV between the screen and the screen frame. • You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278. General Cleaning Warnings: • DO NOT allow liquid to enter the TV through the ventilation slots or any crevice. • DO NOT use any strong or abrasive cleaners as these can scratch the surfaces. • DO NOT use any cleaners with ammonia, bleach, alcohol, benzine, or thinners as these can dull the surfaces. • DO NOT spray liquids or cleaners directly on the TV’s surfaces. • DO NOT scrub or rub the TV harshly. Wipe it gently. Service If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or a Mitsubishi Authorized Warranty Service Center. • DO NOT adjust any controls other than those described in this Owner’s Guide. • DO NOT remove the protective back cover of your TV. Menus not described and shown in this owner’s guide are designed for Factory use and for Authorized Service Personnel. Damage caused to the TV by non-authorized changes or changes to these menus made by non-authorized persons are not covered under warranty. Appendix G: Filter Cleaning Cleaning the Dust Filter Clean the filter annually and whenever you replace the lamp cartridge. Tool needed: Phillips screwdriver 1. Turn the television off and unplug the AC cord. 2. Carefully access the back of the television. If the TV must be moved, use two people. 3. Using a Phillips screwdriver, remove the two screws that hold the dust filter cover in place. 4. Carefully remove the dust filter cover from the TV and set the screws aside. 5. Please follow carefully to open the dust filter cover: while squeezing the grating between your thumb and fingers of one hand, pull the tab with the index finger of your other hand. See (a) and (b) in the illustration to the left. 6. Clean the filter material by dusting with a lint-free cloth. 7. If the filter is soiled, carefully pull it out of the cover and rinse it with water. Do not use detergents or soap on the filter. 8. Completely air dry the filter before placing it back into the dust filter cover. Make sure to place the filter with the notched edge at the upper right corner. 9. Replace the filter in the TV and secure with the screws. IMPORTANT: Never operate this TV without a clean filter in place. ............................................................................................................................................................................................ ........................ Appendix H: Lamp Cartridge Replacement Before you replace the lamp cartridge please note the following: CAUTION: If the television is on, press POWER to turn it off. Allow the television to cool for one hour before attempting to replace the lamp cartridge. LAMP LIFE The light source for this television is a lamp, which is part of a lamp cartridge assembly. The actual life of the lamp in this television can vary, based on the lamp itself, the air temperature around the TV while it is operating, and your viewing patterns. Warmer air or poor ventilation shortens the lamp life, as does turning the television on and off frequently. When the end of the lamp’s life is approaching, the TV displays a warning message for one minute when you power on the TV. The message will reappear the next five times you turn on the TV. After you change the lamp cartridge, you must reset the lamp reminder through the TV Setup menu. Otherwise, the warning message will appear again too soon. Mitsubishi warrants the lamp for one (1) year from date of the original purchase at retail. It is likely, however, that the lamp will last significantly longer than this. TO ORDER A NEW LAMP: While Under Warranty After Warranty Call (800) 332-2119. Please have model number, serial number, and TV purchase date available. Call (800) 553-7278. Order lamp part number 915P028010. WARNING: Do not remove the lamp cartridge immediately after turning off the television. You may get burned because of the lamp’s high temperature. Allow the television to cool for one hour before attempting to replace the lamp cartridge. Do not remove the ...
Эта инструкция также подходит к моделям:Телевизоры - WD-52528 (6.76 mb)
Телевизоры - WD-52528 (6.76 mb)
Телевизоры - WD-62527 (6.76 mb)
Телевизоры - WD-62528 (6.76 mb)