|
Фрагмент инструкции
If the refresh rate of the PC graphic card cannot be changed,change the PC graphic card or consult the manufacturer of the PC graphic card. Line frequency (Khz) Frame frequency (Hz) VGA SVGA XGA 640*480 31.5KHz 60Hz 800*600 37.9KHz 60Hz 1024*768 48.4KHz 60Hz Mode Resolution Note: All above listed are subject to VESA Criteria. YPbPr Input Connect the DVD video outputs (Y, PB, PR) to the COMPONENT(Y, Pb, Pr) IN socket on the TV and connect the DVD audio outputs to the AUDIO IN jacks on the TV, as shown in the figure. If your DVD player does not have component video output, use S-Video. 1. Turn on the DVD player, insert a DVD. 2. Use the button on the remote control to select How to connect NOTE: How to use SOURCE VGA IN Connection Instructions Connection Instructions COMPONENT (If connected to S-VIDEO,select the S-VIDEO external input source.) 3. Refer to the DVD player's manual for operating instructions. Component Input ports To get better picture quality, connect a DVD player to the component input ports as shown below. S-VIDEO Input -To avoid picture noise (interference), leave an adequate distance between the VCR and TV Connection and use steps: 1.Read the user guide supplied with your AV devices and ensure that it has S-Video connectors; 2.Make sure that the power of the LCD-TV and the AV device are switched off; Connection Option 1 Set VCR output switch to 3 or 4 and then tune TV to the same channel number. Connection Option 2 1. Connect the audio and S-VIDEO cables from the VCR's output jacks to the TV input jacks, as shown in the figure. 2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner s manual.) 3.Turn on the power of the LCD-TV first ; and then turn on the power of the AV device; 4.Press the SOURCE button to set the video . input mode of the LCD-TV to S-VIDEO mode . VCR 1 2 Connection Instructions Connection Instructions SCART Input 1.Connect the scart lead from the external device(DVD players, settop boxes or game consoles, to the TV SCART socket. 2.Press SOURCE to select SCART mode. 3. Press Play button on external equipment and it should appear on the screen. SCART External equipment HDMI Input HDMI Devices Connect the cable from the HDMI devices to the TV HDMI, as shown in the figure. Howtouse 1. Select the HDMI source by using the SOURCE button on the remote control. 2. Operate the corresponding external equipment. Refer to external equipment operating guide. HDMI TV HDMI HDMI Devices Note: The audio cable included with the TV should be used when connected with PC/ COMPONENT/S-VIDEO. Wall Mounting Use 4 machine screws(M4x8mm not included) to mount the TV on the Bracket(not included) For the Wall Bracket-Refer to the user instructions supplied with the wall bracket(not included) Remark: Wall mount is not applicable to 15 inch TV Basic Operating Instructions Basic Operating Instructions Turn on the LCD-TV STANDBY OPEN/CLOSE SCAN SWAP CALL MUTE 1 2 3 4 5 6 7 8 9 0 -/-- SOURCE DTV/DVD P+ P- V-V+ MEN...
Эта инструкция также подходит к моделям:Телевизоры - L15T11W-C (1.68 mb)
Телевизоры - L22T11W-A (1.68 mb)
Телевизоры - L19T11W-A (1.68 mb)
Телевизоры - L19T11W-C (1.68 mb)