Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
If you select the video signal, please set the input signal source of LCD TV to AV mode. ©Yellow (video) ©White (audio, L) ® Red (audio, R) To video input To audio inputs To S-VIDEO input VCR, DVD etc. 5-L® © To video output =0gDMD- To audio outputs (NOT SUPPLIED) EtMUD- To S-VIDEO output Note: Composite video is the most common used signal, but the picture quality is not as high as S-video. S-VIDEO Signal Connection Connect the S-video terminal on the TV to the output of AV equipment using a S-video cable. If you select S-video signal, please set the input signal source of LCD TV to SVIDEO mode. S-Video is a signal format which transfers the color and brightness of the picture with higher quality than a 14 Installation (continued) The PC input signal connection Connect the VGA(D-sub) input interface on the TV to the output of PC equipment through Min D-sub 15 pin cable as illustrated.Forthe audio connection.use an audio cord that matches the audio output terminal on the computer. If you select PC signal, please set the input signal source of LCD TV to VGA mode. •> (§)(<2)(#) © (•) •) © (<2) (•) ©©©ip Q ▲ i A ▲ A ▲▲▲▲▲▲▲▲▲▲ ^ VGA PC-ALDIO A Q Q AUDO^ft PHONE ^-AUDO^Q ® ^-AUDO^Q S"™E° RF ^- HDTV IN -^ 0 ^-AVOUT—^ ^-AVIN-^ ^ Blue (Pb) 1 Tianf y) (s§ (®) (M Set-Top Box, DVD player, etc. (Not Supplied) Rear of the STB, DVD Notes: The Y, Pb, Pr outputs on your DVD player are sometimes labeled Y, Cb, Cr. If so, connect the cables to like colors. 17 Basic Operations Turning on 1 Connect the power correctly, then the red indicator lights up and the unit is in STANDBY mode. 2 Press the POWER ((¿))button on the remote control or on the unit to turn on the TV set.The indicator LED will turn to yellow. Turning off 1 With the power on, press the POWER ((¿)) button to turn off the TV and put the TV in STANDBY mode, the indicator LED will turn to red. 2 If you want to turn off the power completely, unplug the power cord from the wall outlet. (?) Note: Do not switch the on/off state of the unit quickly. The interval of the turning on and turning off should be more than 5 seconds. Selecting inputsignal 1 Press the SOURCE button on the unit orBbutton on the remote control. The screen displays the menu as shown on the right. 2 Press CH^/^ to highlight your desired input signal source. Press VOL+/- or wait for about 4 seconds and the desired signal SOURCE \ TV AV SVIDEO YPbPr/YCbCr VGA '— TV / (? Note: All buttons shown in the manual are located on the remote control unless otherwise indicated. 18 Main On-Screen-Display (OSD) introduction 1 Press MENU button to display menu screen. 2 Press VOL+/- to select the menu. 3 Press CH^ to access the menu. 4 Press CH^/^ toselecttheitem. 5 Press VOL+/- to adjust the item. 6. Press...