AUDIOVOX.COM 128-8307 PLV36260CS10 / AUDIOVOX Printed in China 811-362691W080 I/B 811-362691W080 SIZE : 148 X 210MM MATERIAL : 80g WOODSFREE PAPER SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. PLACEMENT INFORMATION • Do not use this unit in places which are extremely hot, cold, dusty or humid. • Do not restrict the air flow of this unit by placing it somewhere with poor air flow, by covering it with a cloth, by placing it on bedding or carpeting. SAFETY INFORMATION • When connecting or disconnecting the AC power cord, grip the plug and not the cord itself. Pulling the cord may damage it and create a hazard. • When you are not going to use the unit for a The lightning flash with arrowhead symbol, long period of time, disconnect the AC power within an equilateral triangle, is intended to cord. alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a CONDENSATION INFORMATION risk of electric shock to persons. • When left in a heated room where it is warm and damp, water droplets or condensation may The exclamation point within an equilateral form inside the equipment. When there is triangle is intended to alert the user to the condensation inside the unit, the unit may not presence of important operating and function normally. Let the unit stand for 1-2 hours maintenance (servicing) instructions in the before turning the power on or gradually heat literature accompanying the appliance. the room and let the unit dry before use. The symbol for Class II (Double Insulation) RATING PLATE LOCATION The rating plate is located on the rear of unit. CAUTION • DANGER OF EXPLOSION IF BATTERY IS FCC STATEMENTS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. NOTE: This unit has been tested and found to • TO PREVENT ELECTRIC SHOCK, MATCH comply with the limits for a Class B digital device, WIDE BLADE OF PLUG TO WIDE SLOT OF pursuant to Part 15 of the FCC Rules. These limits WALL OUTLET, THEN FULLY INSERT. are designed to provide reasonable protection • USE OF CONTROLS OR ADJUSTMENTS OR against harmful interference in a residential PERFORMANCE OF PROCEDURES OTHER installation. This unit generates, uses and can THAN THOSE SPECIFIED MAY RESULT IN radiate radio frequency energy and, if not installed HAZARDOUS RADIATION EXPOSURE. and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is not guarantee that interference will not occur in a particular installation. If this unit does cause harmful WARNING : interference to radio or television reception, which • TO PREVENT FIRE OR SHOCK HAZARD, DO can be determined by turning the unit off and on, NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. the user is encouraged to try to correct the DO NOT PLACE OBJECTS FILLED WITH LIQUIDS interference by one or more of the following ON OR NEAR THIS UNIT. measures: • SHOULD ANYTROUBLE OCCUR, DISCONNECT -Reorient or relocate the receiving antenna. THE AC POWER CORD AND REFER SERVICING -Increase the separation between the unit and TO AQUALIFIED TECHNICIAN. receiver. -Connect the unit into an outlet on a circuit different from that to which the receiver is connected.WARNING: Changes or modifications to this unit -Consult the dealer or an experienced radio/TV not expressly approved by party responsible for technician for help. compliance could void the user authority to operate the unit. E - 1 FPE2608_ib_eng_1-13.pmd 1 1/15/2008, 12:54 PM IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with a dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (Including amplifiers) that produce heat. 9) Do not defect the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your wall outlet, consult an electrician for replacement of the obsolete outlet. 10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11)Only use attachments / accessories specified by the manufacturer. 12)Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. 13)Unplug this apparatus during ligh...
)
Войти: