Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Press the power switch or the button on the remote control to turn on the TV. 2 ) Press the power switch or the button on the remote control to turn off the TV. 4. Signal source selection Press the TV/AV button to select TV or AV mode. 5. Air/Cable selection You can select the signal receiving method according to the following steps: PRESET 1 ) Press the MENU button repeatedly until the PRESET menu appears as shown on the right. 2 ) Press the CH+ or CH-button to select the item ANTENNA. 3 ) Press the VOL-or VOL+ button to change the item between AIR and CATV. 6. Channel search 1 ) Press the MENU button repeatedly until the PRESET menu appears as shown on the right. 2 ) Press the CH+ or CH-button to select the item AUTO-SEARCH. 3 ) Press the VOL-or VOL+ to start to auto-search programs. 7. Picture adjustment1 ) Press the MENU button, and the PICTURE menu appears as shown on the right. 2 ) Press the CH+ or CH- to select the item you want to adjust. 3 ) Press the VOL-or VOL+ to adjust the item. 8. Sound adjustment 1 ) Press the VOL+ or VOL-button to adjust the volume. 9. Timer setting 1 ) Press the MENU button repeatedly until the CLOCK menu appears as shown on the right. 2 ) Press the CH+ or CH- to select the item you want to set. 3 ) Press VOL- to set hour and press VOL+ to set minute. POSITION 17 SKIP OFF ANTENNA AIR AUTO-SEARCH AdjustSelect PRESET POSITION 17 SKIP OFF ANTENNA AIR AUTO-SEARCH Adjust Select PICTURE BRIGHT 75 CONTRAST 80 COLOR 50 SHARP 50 TINT 00 CORING OFF BLACK STRETCH ON Select Adjust CLOCK TIME : ON-TIME : OFF-TIME : ALARM : BESPOKE-TIME : POSITION Select Adjust Note1: All keys mentioned above are on the remote control unless indicated otherwise. Note2: For more detailed information, please refer to the owner's manual. -4 -5- Learning about your new TV You can operate your TV by using the buttons on the front panel or the remote control. The terminals on the back panel provide all the connections you will need to connect other equipment to your TV. Caution: The TV power plug has one prong wider than the other and will fit only one way into a standard electrical outlet ( 120VAC,60Hz ). If the plug does not fit into the outlet, try turning it around. If the plug still does not fit, the outlet is probably non-standard and must be replaced by a qualified electrician. Do not tamper with the plug or try to force it into a non-standard outlet. Selecting a location for the TV 1 ) Place the TV on the floor or on a sturdy platform in a location where light does not directly hit the screen. 2 ) Place the TV far enough from the walls to allow proper ventilation. Inadequate ventilation may cause overheating, which may damage the TV. Note: The above figures are for reference only, please refer to the actual units to determine their appearance. If you haven't connected electronic equipment before, or you have been frustrated in the past, you may wish to read this section. (Cables are not supplied) Caution: Do not plug the TV in until you have finished connecting all of your equipment. Connecting your TV Front Controls Power Indicator Infrared Sensor Power Switch Front Panel Volume Down TV/AV Selection Channel Up Channel Down Volume Up MENU Back Connections AC Cord and Plug IN S-VIDEO VIDEO AUDIO MONO Y Cb Cr Antenna Component Video Input Audio Input Video Input S-VIDEO Input IN S-VIDEO VIDEO AUDIO MONO Y Cb Cr ANT75 AV/TV MENU VOL CH AV/TV MENU VOL CH VIDEO AUDIO/L AUDIO/R Lateral AV Video Input Audio Input (Right) Audio Input (Left) To enjoy the programs coming from your audiovisual equipment such as VCR, DVD, Satellite receiver, Camcorder, Audio amplifier etc, the signal must be received by the set via the AV input terminals at rear. Connect the devices as the shown below. Note: When connecting YUV (Y Cb Cr) jacks, Audio Left and Right cables should be connected to AUDIO INPUT terminals. Connecting the audiovisual equipment Connecting your TV To enjoy the signal transmitted by your local TV station, you need an indoor or outdoor antenna ( not supplied ). Perfect picture quality requires a good signal and generally means that an outdoor antenna must be implemented. The exact type and location of the antenna will depend on your particular area. Consult your local dealer or service personnel for best advice. If you are a subscriber of your local CATV net, the outdoor or indoor antenna is not needed. Connect the equipments as the following figure. -6- Connecting the antenna Antenna Socket Rear View IN S-VIDEO VIDEO AUDIO MONO Y Cb Cr ANT75 OUTPUT VIDEO LEFT(MONO) RIGHT To the input terminals PLAY VIDEO TAPE, DVD etc. TV OUTPUT Y Cb Cr VCR/DVD VCR/DVD Loosen the screw Insert the feeder in Tighten the screw Plug(not supplied) Adaptor (not supplied) The signal comes from: An outdoor antenna An indoor antenna CATV net Twin-Lead Feeder(300 W ) Coaxial Cable (75W ) IN S-VIDEO VIDEO AUDIO MONO Y Cb Cr Connecting your TV Connecting a cable converter box This television has an extended tuning range and can tune mo...
Эта инструкция также подходит к моделям:Телевизоры - C2005US (975.8 kb)
Телевизоры - C2005US (975.8 kb)