Read these instructions carefully to safely use your N-Verter. Lenmar’s N-Verter is an electronic device that converts low voltage DC (direct current) electricity from a battery to 110/120VAC (alternating current) standard household power.The AC output of this product is a modified sine wave with a voltage of 110/120 volts. With your Lenmar N-Verter you can power your laptops, computerized games, cell phones, camcorders, power tools, reading lamps, fans, and more. Important: Before using your N-Verter, read and understand this owner’s guide. Save these instructions–this owner’s guide contains important safety instructions. 1. Troubleshooting Symptom Problem / Solution An AC device is connected The AC device has higher wattage demands or requires and turned on causing the a larger start-up surge current than the N-Verter’s N-Verter to shut down maximum rating can allow. The N-Verter unit is too immediately. small for this device. A higher rated N-Verter is needed to deliver the power that the AC device demands. Otherwise, use only lower power AC devices. Green LED on the N-Verter On many vehicles, the ignition key must be “on” for unit does not light and/or the power to be present at the cigarette lighter socket. AC device does not operate Make sure the key is on. The N-Verter plug tip may be fitting too loosely. Use the slide control on the plug tip to adjust and ensure a snug fit and re-insert. Battery voltage may be too low. Recharge the vehicle’s battery and attempt again. Vehicle fuse may be blown. Replace the vehicle’s fuse with the same type and rating. Make sure you are not overloading the socket or the fuse will blow again. Buzzing sound in Many inexpensive stereos or portable players will buzz audio systems when connected to the N-Verter because the modified sine wave of the N-Verter is not properly filtered by the electronic device’s power supply. Higher quality devices will not buzz with the N-Verter. Television If the television signal is weak, the use of the N-Verter interference will cause a visual disturbance. Move the N-Verter away from the TV, antennae and/or the antennae cables. You may attempt to merely adjust the placement of the antennae or cables. Inferior antennae and cables will also cause TV interference during operation of the N-Verter. Safe Operating Guidelines WARNING! Shock hazard The N-Verter generates the same AC power as a normal household wall outlet. • Operate only in ventilated area away from flammables, flames and accumulating dangerous or explosive fumes • Do not expose unit to water, rain or snow • Always turn OFF unit by removing it from the DC cigarette lighter outlet when not in use • Avoid exposure to direct sunlight and extreme temperatures (60-80°F or 15-25°C) • Do not insert foreign objects into the outlet. • Do not open the unit: no replaceable parts inside • Consult motor vehicle’s manual to determine cigarette lighter socket’s maximum power rating and fuse rating before attempting use in vehicle. • Unit will not and should not operate heat-generating appliances such as hair-dryers, microwave ovens, electric blankets, toasters, etc. • Compatible only with vehicles that have 12VDC Negative Ground electrical systems Failure to follow the above may result in personal injury or damage to the N-Verter. Special Features: NVD150S – A swivel tip design allows you to adjust the N-Verter’s position and avoid interference with the gear shift, cup holders, etc., in vehicles where the DC socket location causes problems with standard units. NVD175X – An auxiliary DC socket is provided to allow the use of an additional 12VDC accessory. Be careful that the power requirements of the N-Verter and the additional DC accessory plugged into the auxiliary socket do not exceed the maximum power output of the vehicle’s DC socket. 2. Specifications: Model - NVD75 Maximum output power 75W (15 min.) Surge output power 200W (5 sec.) Continuous output power 60W (4 hr.) Output frequency 60HZ+/-2HZ Output voltage range 105V-125V AC , Modified Sine Wave Input voltage range 11.5V-14V DC AC receptacle 1x 3 Prong Socket Dimensions 4.5 x 2.25 x 1.25 inches Model - NVD150S Maximum output power 150W (5 min.) Surge output power 200W (5 sec.) Continuous output power 140W (4 hr.) Output frequency 60+/-2HZ Output voltage range 105V-125V AC , Modified Sine Wave Input voltage range 11.5V-15V DC AC receptacle 1x 3 Prong Socket Dimensions 5.25 x 2.5 x 1.75 inches Model - NVD175X Maximum output power 175W (15 min.) Surge output power 300W (5 sec.) Continuous output power 140W (4 hr.) Output frequency 60+/-2HZ Output voltage range 105V-125V AC , Modified Sine Wave Input voltage range 11.5V-15V DC AC receptacle 1x 3 Prong Socket Dimensions 5 x 3.25 x 1.75 inches All units also incorporate low voltage shut-off, over voltage shut-off, over-heat protection and short-circuit protection. Operating your N-Verter 1. Plug the N-Verter into your vehicle’s lighter socket. If the socket is too wide and the plug tip of th...