Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Problem/error
Cause
What to do ...?
The dryer does not work. • No voltage from the mains
• Check if the mains plug is
socket.
correctly inserted into the mains
socket.
• Check the fuse.
There is voltage at the
• Programme was not started • Reread the instructions for use
mains socket, but the
in accordance with the
again.
drum does not spin and
instructions.
• Push the door towards the
the dryer does not work.
• The door is not properly
appliance.
closed.
• Empty the water container
• Water container is full.
(see section Cleaning and
• Delayed start function has
Maintenance).
been selected.
• Wait until the time indicated on
the display elapses.
Laundry is not dried, or
• Filters are not clean. The
• Clean the filters.
drying time is longer
room is not sufficiently
• Install the dryer in an
than 4h.
ventilated.
appropriate room (see section
• Inappropriate temperature
Installation ...)
in the room.
• Check if the temperature in
• Laundry was not sufficiently
the room where the dryer is
wrung or spun.
installed is too high (over 25 °C)
• Amount of laundry dried in
or too low (below 10 °C).
the appliance is too large or • Laundry inserted into the dryer
insufficient.
was not sufficiently wrung or
spun, or an inappropriate drying
programme was selected.
• Use an appropriate programme
or use the timed programme.
Increase the final level of
dryness for the selected
programme (intensive drying
function).
Unevenly dried laundry.
• The amount of laundry
• Make sure the laundry is sorted
dried at a time is too large.
by type and size of items given
• Drying the pieces of
the selected programme (see
different thicknesses.
section Drying – Preparing the
• Drying the different types
Laundry and the Programme
of laundry.
Table).
Error in the drum
• The light does not turn
• Disconnect the dryer from mains
lighting.
on when the dryer door is
power and call an authorised
opened.
service centre.
On display: F3
• Full water container.
• Empty the water container
• If the water container is
(see section Cleaning and
empty, there is a pump
Maintenance).
failure.
• Disconnect the appliance and
call an authorised service centre.
On display: F4
• Clogged filters.
• Clean the filters.
• If the filters are clean,
• Disconnect the appliance and
there may be a compressor
call an authorised service centre.
failure.
Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call the
nearest authorised service centre.
510549
38
NH-P8ER1_WGB_En.indd 38
2015/08/24 10:55:58
...