Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
. Vision-Impaired Washer/Dryer Kit For washer model WNRD2050 and dryer model DNCD450, a kit is available for the vision-impaired containing Braille overlays that fit over the pads on the washer and dryer control panels. Included in the kit are: Braille overlays for the washer and dryer control panels Braille Reference Keys that explain the operation of the washer and dryer Use and Care Audio Tape Order publication number 14-D242, available from your GE supplier. 1 Clothes Care Selection For cottons and most linens. For loads consisting of cottons and poly-blends. For wrinkle-free and permanent press items. For knits and sweaters with fabric care labels that say “Machine Dry.” For lingerie and special care fabrics. For tumbling items without heat. 2 Heat Settings For regular to heavy cottons. For synthetics, blends and items labeled permanent press. For delicates, synthetics and items labeled Tumble Dry Low. For lingerie and special-care fabrics. 3 START/PAUSE Press START to begin the cycle. Press twice to select the last cycle you used and start the dryer. If you have selected a new cycle, press once to start the cycle. If the dryer is running, press once to interrupt the cycle; press again to continue the cycle. STOP/CANCEL This pad should not be used to interrupt or pause a cycle. Pressing this pad will cancel the current settings and the settings will be lost. “Racetrack lights” Estimated Time Remaining As the cycle begins, you will see the approximate total cycle time in the display. Then “racetrack lights” will flash in the display, in a clockwise direction. This means the dryer is continuously monitoring the amount of moisture in the load. The racetrack lights will continue until the dryer senses a low level of moisture in the load. At that point, the dryer will calculate and display the approximate time remaining. Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips About reversing the door. Tools needed: Standard #2 4 3 2 1 Reversing the Door Tape-tipped Needle-nosed Phillips screwdriver putty knife pliers Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about half way into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in untapped holes. Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT. Rotate the door 180°. Insert it on the opposite side of the opening by moving the door IN and DOWN until the top hinge and the bottom hinge are resting on the top screws inserted in step 1. Remove the remaining screws from the side of the opening from which the door was removed. With these screws secure each hinge at the bottom. Tighten the two top screws of each hinge. Reinsert the plastic plugs on the side from which the door was removed. 8 Consumer SupportTroubleshooting Instructions Loading and using the dryer. Always follow the fabric manufacturer’s care label when laundering. Fabric Care Labels Below are fabric care label “symbols” that affect the clothing you will be laundering. WASH LABELS DRY LABELS Machine wash cycle cycle Normal Permanent Press/Gentle/Do not wash Do not wringwrinkle resistant delicate Hand wash Water temperature Hot Warm Cold/cool (50°C/120°F) (40°C/105°F) (30°C/85°F) BLEACH LABELS Tumble dry Dry Normal Permanent Press/ wrinkle resistant Gentle/ delicate Do not tumble dry Do not dry (used withdo not wash) Heat setting High Medium Low No heat/air Specialinstructions Line dry/ hang to dry Drip dry Dry flat In the shade Bleach symbols Any bleach Only non-chlorine bleach Do not bleach (when needed) (when needed) Sorting and Loading Hints As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer. Try also to sort items according to size. For example, do not dry a sheet with socks or other small items. Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains. Bounce® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions. Do not overload. This wastes energy and causes wrinkling. Do not dry the following items: fiberglass items, woolens, rubber-coated items, plastics, items with plastic trim and foam-filled items. Care and Cleaning of the Dryer The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is not covered by your warranty. The Lint Filter: Clean the lint filt...